Bad ecm?

mbskin

New Member
Sep 10, 2007
1
0
0
Hi Guys and gals, New to this page but need help with the stang. Had some iter work done nothing elec, car sat for 2 months . After work was done went too crank her up and go for a ride batt was dead. hit it with one of these pre charged units .car cranked but, ran like hell, loping like hell! Burning aLot of raw fuel. I checked fuses cause power seat did not work. Found 30 amp fuse feeding convert top and seats blown. found short in pass seat and unplugged and fuse held. Tried to plug fault code grabber to comp but would not connect. Can unplug mass air while running nothing changes. Have I blown my ecm, any ideas would be most helpful,Thanks
 
Check this out. It is a pretty good write up over at Ford Fuel Injection. I was kinda in the same boat as in that I couldn't pull codes. Ended up that the internal trace for the SIGRTN, pin 46 was burned up on EEC. I have some other issues but hopefully this should help. It goes through a step by step guide of how to track the no code prob back to the EEC or wiring. http://fordfuelinjection.com/index.php?p=44
 
Computers seldom fail - it is almost always a bad sensor or bad connection.

Dump the codes and see what the computer says is wrong…Codes may be present in the computer even if the Check Engine light isn’t on.

Here's the link to dump the computer codes with only a jumper wire or paper clip and the check engine light, or test light or voltmeter. I’ve used it for years, and it works great. You watch the flashing test lamp or Check Engine Light and count the flashes.

See http://www.troublecodes.net/Ford/

index.php


index.php


IF your car is an 86-88 stang, you'll have to use the test lamp or voltmeter method. There is no functional check engine light on the 86-88's except possibly the Cali Mass Air cars.

attachment.php


89 through 95 cars have a working Check Engine light. Watch it instead of using a test lamp.

attachment.php


Codes have different answers if the engine is running from the answers that it has when the engine isn't running. It helps a lot to know if you had the engine running when you ran the test.

Trouble codes are either 2 digit or 3 digit, there are no cars that use both 2 digit codes and 3 digit codes.

For those who are intimidated by all the wires & connections, see http://www.actron.com/product_detail.php?pid=16153 for what a typical hand scanner looks like. Normal retail price is about $30 or so at AutoZone or Wal-Mart.

Or for a nicer scanner see http://www.midwayautosupply.com/pc-7208-90-equus-digital-ford-code-reader-3145.aspx – It has a 3 digit LCD display so that you don’t have to count flashes or beeps.. Cost is $30.