I just installed a BBK fender CAI kit in my car.
No matter how I shift it around or angle the tubes
I cant seem to get the tube that goes from the MAF
sensor to the throttle body intake to stop rubbing off
the front strut tower.
There seems to be about a 1/8 inch of clearance between
the two and when the car idles it occasionally hits the body.
I do have Cobra uppers and lowers on it, Im not sure if that is
a issue. Im thinking that these are designed for a factory type
replacement.
I could probably cut off a little on the pipe and that may buy
me a little more clearance.
Has anyone else had this issue before ??
No matter how I shift it around or angle the tubes
I cant seem to get the tube that goes from the MAF
sensor to the throttle body intake to stop rubbing off
the front strut tower.
There seems to be about a 1/8 inch of clearance between
the two and when the car idles it occasionally hits the body.
I do have Cobra uppers and lowers on it, Im not sure if that is
a issue. Im thinking that these are designed for a factory type
replacement.
I could probably cut off a little on the pipe and that may buy
me a little more clearance.
Has anyone else had this issue before ??