BBK LT install

[TrophyHead]

Hi Friends.

Whats the easiest way, to go about doing this?

Do I have to take the steering shaft off? And jack the motor up to fit the passenger side? Any tips or advice greatly appreciated.

 

[RYC CUKR]

On my 88 I had to unbolt the ragjoint on the drivers side so that I would get the drivers side header in. On the passenger side I dropped the starter, put the header in and then reinstalled the starter. A little extra work but overall not too bad.

 

[NKau]

Driver's side on mine was cake; did not need to remove the steering shaft. For the passenger side, we unbolted both motor mounts, and got the engine up a ways to slide the header in.

 

[bloopbloob]

steering shaft was fine on mine. all i had to do is just tilt the pass. side of the engine up a bit to get it to fit in. the x-pipe caused the most headaches

 

[88mouse]

I just picked the motor up, and they went right in.