Best mod for $299?

Stang2003GT

Member
Jul 7, 2003
254
0
16
There are alot of mods out there that are at or under the three hundred dollar mark. You can get a Diablo tuner, C&L Plenum with 75mm TB, Pullys, Cold air Intakes and thats were it drops off. All of these are easy to do and dont require labor. So what is the best HP mod for three hundred dollars?
 
MGW.gif


MGW Shifter $180

BBK Pullies $132
 
Will I feel the difference with a Diablo tuner? And if I run unlead 100 octain with there be more power then 93? I figure at 100 you could raise the timing more and lean the engine out for more power.
 
It will be so much better for daily driving, you'll wonder how you lived without it. Hell, I have the MGW shifter, but only went to the tracks twice since the install (last last Christmas).

Find a buddy with a short throw shifter inside, and feel the difference. Finding 5th might be a hassle for some, but I'm equipt with gorilla arms and reaching over isn't a problem for me.
 
My firend has a Pro 5.0 shifter and I dont care for it, I just want a little more power for passing people and stuff, I never use 5th gear and 4 is like my overdrive and I catch my self in 3rd alot doing 45 mph. I will get a shifter when I get gears.

Till then how do I pully a few more ponys out or my car?
 
Stang2003GT said:
I dont race.

Why the HELL do want to mod your car then? lol...a new shifter will do you some good at the track.

Also, where are you guys finding these cheap as5 tuners? Last time I checked xcal2's were more than $300. Why get a Diablo when you can get the best? :shrug:
 
A shifter is your best mod if you do OR dont race. It will greatly compliment some rear end gears if you DO race..and will greatly enhance daily driving if you DONT race.

Seriously, get an MGW, accept no substitute, and you will be loving your car more.
 
The problem is $300 isn't alot to work with for hp. Save for some cams, long tubes, or a handheld programmer. But don't expect much SOTP from anything else.
Gears and shifter make driving more fun and I do recommend those.
If $300 is absolutely all you can work with then try steeda pullies. You could get a super cheap plenum/TB but #1 don't go super cheap and #2 not much SOTP there, but it adds up as you mod.
Good luck with your decision.