Blinkers
- Thread starter Guero
- Start date
-
Sponsors (?)
CManT1914
New Member
Could be your multi-function (turn signal) switch. When mine went out, my brake lights and turn signals all stopped working.
bill302
Active Member
replace the electronic solid state indicator flasher located in the fuse junction panel,under the left hand side of the fuse panel.
to replace the flasher unit,perform the following
1. disconnect the negative battery cable
2. remove the fuse junction panel
3. pull the indicator flasher straight out of the fuse junction panel.
to install:
4. align the indicator flasher with the fuse junction panel and press it in to place until fully seated.
5. install the fuse junction panel.
6. connect the negative battery cable.
to replace the flasher unit,perform the following
1. disconnect the negative battery cable
2. remove the fuse junction panel
3. pull the indicator flasher straight out of the fuse junction panel.
to install:
4. align the indicator flasher with the fuse junction panel and press it in to place until fully seated.
5. install the fuse junction panel.
6. connect the negative battery cable.
MysteryMachine
Active Member
SeventyMach1
Keep it lubed .... keep it straight .... and keep
Have you upgraded the exhauster?
It tends to cause this problem. Be sure to use synthetic fluid .... it lasts longer.
It tends to cause this problem. Be sure to use synthetic fluid .... it lasts longer.
MysteryMachine
Active Member
MysteryMachine
Active Member
nah you gotta drill a hole. stupid ford thought buy sealing them the fluid would stay in there but it didn't work
MysteryMachine
Active Member
eh pulling the battery is over kill for a flasher book tells you to pull it for putting gas in the damn car just about. Yes the flasher should be round
