Hey guys, i have been building a ford 302 for a while now that i will be putting in my 89 lx i just have some questions for you guys. I ave 351 w heads on the engine and i need a 4 barrel intake to go on it (previous owner ran a 2 barrel) the one on it now is a stock 302 intake i was just wordering if you guys had suggestions on intakes to look for that are desirable. I will be putting a edlebrock 650 cfm on it and need a low rise intake due to the fact i do not want to cut the hood. Another question i was wondering about was build the bottom end i mistakenly bought a 28oz crankshaft when my motor was a 50oz set up i now need a new fly wheel and balancer for it. Do the 28oz and 50oz share the same teeth count and diameter. The tranny is a c4 and was wondering if you guys could link me some products to look at. Finally i know this is not about the engine but today im going to buy a 8.8 rear end for it that came out of another v8 fox i was wondering if the driveshaft i have for the swap will fit without customizing it. The other car my drivetrain came out of was a 7.5 rear end car so i just wanna know if ill need a new driveshaft or not (The rear end is $50 and i got ford racing gears for it for free). Thanks alot if you actually sat through this and read it and if you can help me out it will be greatly appriciated