Hi Guys,
Need some help on where to shop as well as a couple general questions.
So far we have brand new VT sage 2 NA cams, Manley springs, and cam gears lined up for $800 shipped new (I think is a steal!!). If that falls through I found a place to get brand new Crower stage 2 high lifts with crower springs for a similar price.
Found a place for FRPP 3.73 gears with installation kit and bearing kit for around $280 shipped. Is that a good price?
I'm having trouble with the exhaust however. BBK has a good price for long tubes (around $450) but I don't want to deal with the tranny interference issue. Hooker is very expensive and can't find any hedmans Can someone point out a place to find that. Also, since we are going long tubes we will have to go with a short x-pipe correct?
Another thing I am having issues on is finding a damn intake manifold. I found the Trick flow street heat but on the pricing I can't tell if it's th whole package (plenum and lower manifold) or just the lower monifold. Can someone point out a place to get them. Or a better intake manifold that isn't outrageous on the pricing.
What clutch does everyone recommend given the torque this set-up will make?
The throttle body will most likely be a BBK but that may change and I can find TB's anywhere for the 4.6.
We are going we an MSD 6al package as well. Also going with the SCT XcalII and a larger MAF. I think stock fuel will be sufficient for the power increase but we'll see.
The car already has a K&N intake and piping and a h-pipe back flowmaster exhaust and that's it on the mods. We were going to go with Patriot stage II heads but decided to hold off until later this summer. Is there anything else I should add to the list or is this a good start. I'm new to the modular mustangs.
Any help is appreciated guys! Thanks!
Take care,
Josh
Need some help on where to shop as well as a couple general questions.
So far we have brand new VT sage 2 NA cams, Manley springs, and cam gears lined up for $800 shipped new (I think is a steal!!). If that falls through I found a place to get brand new Crower stage 2 high lifts with crower springs for a similar price.
Found a place for FRPP 3.73 gears with installation kit and bearing kit for around $280 shipped. Is that a good price?
I'm having trouble with the exhaust however. BBK has a good price for long tubes (around $450) but I don't want to deal with the tranny interference issue. Hooker is very expensive and can't find any hedmans Can someone point out a place to find that. Also, since we are going long tubes we will have to go with a short x-pipe correct?
Another thing I am having issues on is finding a damn intake manifold. I found the Trick flow street heat but on the pricing I can't tell if it's th whole package (plenum and lower manifold) or just the lower monifold. Can someone point out a place to get them. Or a better intake manifold that isn't outrageous on the pricing.
What clutch does everyone recommend given the torque this set-up will make?
The throttle body will most likely be a BBK but that may change and I can find TB's anywhere for the 4.6.
We are going we an MSD 6al package as well. Also going with the SCT XcalII and a larger MAF. I think stock fuel will be sufficient for the power increase but we'll see.
The car already has a K&N intake and piping and a h-pipe back flowmaster exhaust and that's it on the mods. We were going to go with Patriot stage II heads but decided to hold off until later this summer. Is there anything else I should add to the list or is this a good start. I'm new to the modular mustangs.
Any help is appreciated guys! Thanks!
Take care,
Josh