I'm finally going to put in my TFS stage 1 Cam but the instructions that came with it (in the top end kit) said I needed to machine the retaining plate. is there anything eles I need to do?
CAM retaining plate
- Thread starter 95gtdude
- Start date
True 5.0
Member
I'm not familiar with that cam but machining the retaining plate really doesn't make sense. What is the reason for this?
have to countersink the 2 screw hole for clearance so the instructions say. not really sure why, I was just wondering what everyone eles did with this CAM. I know that some people have the Trick Flow Stage 1 cam.
SorsCode
20+ Year Stangneter 
I just installed my tfs1 cam about 3 hours ago.. didn't have to do a thing to the retaining plate.
Did you guys use your original timing set or a new one? because I tried both and I either had no cam play or too much (0.001-0.007 is the limit of play you should have)!
SorsCode
20+ Year Stangneter
Similar threads
