Again, as far as the sizes, I was just going by what it said on the lid of the Dorman drawer. I know 1/4" sounds way small, but maybe they're going by inside diameter instead of thread size...?
The part # and pic matched the part that I wound up using, so maybe their description is wrong (but the part # should be correct). I dunno. All I know is that it fit like a glove. Take out your ECT, mosey on over to Autozone with that part #, and see if it matches, I guess.
The part # and pic matched the part that I wound up using, so maybe their description is wrong (but the part # should be correct). I dunno. All I know is that it fit like a glove. Take out your ECT, mosey on over to Autozone with that part #, and see if it matches, I guess.
I believe this is what you need
Auto Meter
Did more looking into it, the manifold has a 1/2" NPT opening for that sensor, so there is your outer dimension. So im thinking its a 3/8" NPT female end that is needed.
Auto Meter
Did more looking into it, the manifold has a 1/2" NPT opening for that sensor, so there is your outer dimension. So im thinking its a 3/8" NPT female end that is needed.