• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Car wont start Help please

  • Thread starter Thread starter jstang209
  • Start date Start date Jul 17, 2005
J

jstang209

20+ Year Stangneter
Jun 3, 2004
640
2
18
Stockton 209
Jul 17, 2005
#1
  • Jul 17, 2005
  • #1
Today was the first day i drove the car after the swap.. i have most necessary stuff connect except for sum vaccum lines.. so i started it and drove it the the muffler shop and what not.. and then stopped to get gas and it wouldnt start.. it dont seem like the battery bc my lights and power stuff worked but we tried jumpin it neways and it didnt work.. i tried a screw driver on both the soilnoids and that didnt work, we tried to push start it and that didnt work.. when i turn the key it turns over a lil, but theres a loud ass whining noise.. that i never heard befor.. i was thinkin its prolly my starter but then that noise throws me off.. Any help is apprecited..thanks
 

trents99

Founding Member
Jun 28, 2002
438
0
0
Hampton, GA
Jul 17, 2005
#2
  • Jul 17, 2005
  • #2
Where is the whine coming from front or back? If it's the back I'd say fuel pump.
 

TomCat

New Member
Apr 19, 2005
412
0
0
Utah
Jul 17, 2005
#3
  • Jul 17, 2005
  • #3
So you couldn't push start it, and it only turns over a little when you crank it? If your fuel pump was bad, it would still crank over just fine... if it was only your starter, you'd be able to push start it.
 

HISSIN50

"How long does it take to get help in here?
15 Year Member
Nov 29, 1999
31,179
33
129
Jul 17, 2005
#4
  • Jul 17, 2005
  • #4
Are you sure your positive and negative battery connections and motor grounds are up to par? If one is insufficient, even a jump start wont help much. Resistance in wiring tends to go up with heat, so it might have started cold but not hot.

Good luck.
 

NakedRaygun

New Member
May 8, 2005
93
0
0
Chicago, Illinois
Jul 17, 2005
#5
  • Jul 17, 2005
  • #5
HISSIN50 said:
Are you sure your positive and negative battery connections and motor grounds are up to par? If one is insufficient, even a jump start wont help much. Resistance in wiring tends to go up with heat, so it might have started cold but not hot.

Good luck.
Click to expand...
I agree 100%, this just happened with my friends car. Just clip the wires (as they could be messed up from corrosion) and put them back in. Also go to the wire at your starter (bottom right side) and take of the clip and rub it with some sand paper, the same where it bolts in.
 
J

jstang209

20+ Year Stangneter
Jun 3, 2004
640
2
18
Stockton 209
Jul 17, 2005
#6
  • Jul 17, 2005
  • #6
the thing is it started up fine almost 10 times befor we stopped at the gas station.. it was hot and all.. and i dont think i connect everyground.. just a couple of them and the main ground of course.. btw the whine is in the front of the car.. o and both my battery cable are brand new!
 
8

83Rag

Founding Member
Feb 22, 2001
66
0
6
Kittanning PA
Jul 17, 2005
#7
  • Jul 17, 2005
  • #7
Ignition Module? They fail without warning.... just like what happened to me the other nite.....
 
J

jstang209

20+ Year Stangneter
Jun 3, 2004
640
2
18
Stockton 209
Jul 17, 2005
#8
  • Jul 17, 2005
  • #8
its like the engine is whining when i try to start it.. i really never heard that sound.. the tow truck driver said he never heard that sound either..
 
J

jstang209

20+ Year Stangneter
Jun 3, 2004
640
2
18
Stockton 209
Jul 18, 2005
#9
  • Jul 18, 2005
  • #9
well i just went a tested my starter.. it fine.. wat should i check now?
 
8

87'GTstang

New Member
Feb 16, 2004
1,025
0
0
Jul 18, 2005
#10
  • Jul 18, 2005
  • #10
Does the drive pinion of your starter make contact with the flywheel (the sound you describe sounds like it does when the starter free-wheels)?

Noise-wise that's about all I can think. Does the engine rotate at all (crank but no start)?
 
J

jstang209

20+ Year Stangneter
Jun 3, 2004
640
2
18
Stockton 209
Jul 18, 2005
#11
  • Jul 18, 2005
  • #11
turn out my powersteerin pump froze.. and the pulley wont turn.. that wat the screetching was.. the pulley trying to turn haha..
 
You must log in or register to reply here.

Similar threads

T
Help with a 95 5L crank no start
  • TheBubbaJoe
  • Nov 4, 2025
  • 1994 - 1995 Specific Tech
Replies
3
Views
406
1994 - 1995 Specific Tech Nov 5, 2025
AeroCoupe
Drivetrain 83’ Glx convertible C5 Trans help!
  • JacksonJared2113
  • Dec 25, 2025
  • Fox 5.0 Mustang Tech
Replies
2
Views
334
Fox 5.0 Mustang Tech Dec 26, 2025
JacksonJared2113
D
Fuel Crank/No-Start Issue
  • dzolalaw
  • Aug 20, 2024
  • Fox 5.0 Mustang Tech
  • 2
Replies
39
Views
3K
Fox 5.0 Mustang Tech Sep 15, 2024
AeroCoupe
M
Too much for me to repair in my current housing situation
  • My Drama Magnet 04 Gt
  • Apr 1, 2026
  • The Welcome Wagon
Replies
8
Views
250
The Welcome Wagon Apr 14, 2026
Noobz347
A
need help and advise
  • amps1956
  • Oct 14, 2025
  • Other Auto Tech
Replies
16
Views
545
Other Auto Tech Oct 21, 2025
Mcmahst
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?