I bought a Weiand Action Plus Intake and Holley Street Avenger 570 cfm. I didn't receive the carb yet its on the way. My question is what will I need to install both of them? I went over the instructions with the intake. This is what it says to buy:
Intake Manifold Gasket set
Thermostat housing gasket
Form-a-gasket
Spray gasket adhesive
Pipe plugs
Carburetor base gasket
I want to replace all of the intake bolts and carb studs too. I assume I am using the Standard carb studs. As for the intake I haven't taken anything apart yet. I was hoping somebody would know whether to use 12-point or hex bolts. I want to make sure I have everything before I start. Are there any tricks I should know before installing?
Intake Manifold Gasket set
Thermostat housing gasket
Form-a-gasket
Spray gasket adhesive
Pipe plugs
Carburetor base gasket
I want to replace all of the intake bolts and carb studs too. I assume I am using the Standard carb studs. As for the intake I haven't taken anything apart yet. I was hoping somebody would know whether to use 12-point or hex bolts. I want to make sure I have everything before I start. Are there any tricks I should know before installing?