Check engine light test not working for me

The car is a 88GT manual transmission and bone stock. I do have a functioning test engine light. But when I jump the connector with a Paper clip or wire, the check engine light stays on but does nothing. I am sure I have the connector jumped correctly. Does that have to be in neutral or gear (i tried both). Any help greatly appreciated.
 
To the best of my knowledge, only Mass Air (Califorina) cars made during the 88 model year had a working CEL.

Here's the alternative method...

Dump the codes and see what the computer says is wrong…Codes may be present in the computer even if the Check Engine light isn’t on.

Here's the link to dump the computer codes with only a jumper wire or paper clip and the check engine light, or test light or voltmeter. I’ve used it for years, and it works great. You watch the flashing test lamp or Check Engine Light and count the flashes.

See Troublcodes.net Trouble Codes OBD & OBD2 Trouble Codes and Technical info & Tool Store. By BAT Auto Technical

B.jpg


F.jpg


If your car is an 86-88 stang, you'll have to use the test lamp or voltmeter method. There is no functional check engine light on the 86-88's except possibly the Cali Mass Air cars.

attachment.php


89 through 95 cars have a working Check Engine light. Watch it instead of using a test lamp.

attachment.php


What to expect:
You should get a code 11 (two single flashes in succession). This says that the computer's internal workings are OK, and that the wiring to put the computer into diagnostic mode is good. No code 11 and you have some wiring problems.

Codes have different answers if the engine is running from the answers that it has when the engine isn't running. It helps a lot to know if you had the engine running when you ran the test.

Trouble codes are either 2 digit or 3 digit, there are no cars that use both 2 digit codes and 3 digit codes.

Alternate methods:
For those who are intimidated by all the wires & connections, see Actron® for what a typical hand scanner looks like. Normal retail price is about $30 or so at AutoZone or Wal-Mart.

Or for a nicer scanner see EQUUS DIGITAL FORD CODE READER (3145) – It has a 3 digit LCD display so that you don’t have to count flashes or beeps.. Cost is $30.
 
Thanks Jrichker

But I mean literally not doing anything. WHen I do the jumper method. The CEL just stays on. It doesnt blink or nothing. And I sure I am using the right plug and terminals (I am using you S.I.C post)

What would cause my CEL to not perform as it should when trying to run codes?