Check out my Clutch Fork

[JimBowy]

I assume its had about 166,000 original miles on it. You can see it has some wear on it (on both the metal-springs and on the front... see its shiny).

Now the question is with my new Centerforce clutch, pilot bearing, throw-out bearing, flywheel, etc. should I change this part or try to smooth out the imperfections with a grinder?

Here's the pictures, what do you think?

 

[blk92stangg]

I would just get a new one, they aren't that expensive, if you have any doubts. I would also look at the pivot bolt it sits on for wear, as well as the throwout bearing retainer. Just me tho'

 

[xxxCadillacxxx]

i would definatly not replace it. Its fine, wear on the pivot points will not adversly effect anyhing. The piviot points and te bearing i would defintatly replace though.