i said in my other thread that i was making my own power pipe because i couldn't see spending $185+shipping for a piece of tubing and some rubber elbows. well i finished it today, aside from putting a filter on the end of it, but i have a K&N cone filter coming in the mail. it's a 3.5" pipe.
cost of supplies:
mandrel bent 3.5" aluminum tube = $42
two 3.5" black silicone 90* elbows = $48.97
K&N cone filter = $21.24
total cost = $112.21
i saved myself a good $70 - $80 piecing together my own setup and it looks just as good, if not better, imo.
i modeled it off of the afm 3.5" N/A pipe AF-0104c, but mine doesnt have as sharp of a bend, and i put my MAF sensor in the fender with the filter...
first, here's the afm for comparison:
here's mine:
what do you guys think?
cost of supplies:
mandrel bent 3.5" aluminum tube = $42
two 3.5" black silicone 90* elbows = $48.97
K&N cone filter = $21.24
total cost = $112.21
i saved myself a good $70 - $80 piecing together my own setup and it looks just as good, if not better, imo.
i modeled it off of the afm 3.5" N/A pipe AF-0104c, but mine doesnt have as sharp of a bend, and i put my MAF sensor in the fender with the filter...
first, here's the afm for comparison:
here's mine:
what do you guys think?