cigarette lighter help

91stang50GT

New Member
Nov 1, 2005
57
0
0
when i bought the stang a few weeks ago, many things were not hooked up/wiring harnesses chopped, including the cigarette lighter harness. the harness is completely gone so i took ( i think 18 gauge) wire and ran the positive of the lighter straight to the 12v constant power source in the back of the radio. The lighter works fine now but is this safe to do? Do i need a in-line fuse and if so, about what size?

thanks
 
No that is not safe to do.

you do need circut protection

run the ground to ground and then run the hot to your fuse box. There is a 15 (or 20 I can't remeber off the top of my head) amp fuse there for it (It feeds your horn as well) put the proper conector on the end that goes into the fuse box properly and then run that wire directly to the lighter socket, no splices. Wireing is really easy and fast to do wrong, but it takes time to do it right.

Wireing your car slopily will hurt deep when you are on the side of the road watching your pride and joy burn to the ground, cause you took a shortcut.

pm me if you have any questions on how to wire something properly.
 
Maybe This can Help

35473.gif




:nice:
 
thanks to both of ya.. i wired it up straight to the blue/white wire coming from the fuse box that the cigarette lighter was originally wired to.. i have another wiring question though.. that diagram got me interested in trying to get my horn to work. I have an aftermarket steering wheel (grant) with the horn button in the middle. The two wires are hooked up to the back of the button but nothing happens when pressed, no relay clicking or anything. After looking at the diagram, i traced the Y/LG wire from the relay up to the horn 3-pin contact piece that rubs against the copper plate (behind the steering wheel). I stripped that wire and grounded it and the horn blew. That leaves the problem between that circular copper plate and the horn button itself. Can anyone help?
 
sorry didn't see your other post,
If I understand you right, it sounds like your horn swich might not be working, press the horn switch and check for conductivity for Y/LG to ground. If none, then you can start there.
 
I imagine the radio circuit has a fuse on it already...so assuming the fuse is matched to the wire you used it should be safe (but probably not ideal).

When I say a fuse is matched to the wire, I mean the fuse rating is not too big to protect 18AWG (knowing the insulation material is important when determing the rating of automotive wire).