Clutch Question, and Error code 31 question

[Killerrobotjews]

So my stock clutch cable self adjuster is not working, and it was suggested that i get an aftermarket quadrant and FWA. can someone link me to everything i would need for this part wise?

Also, Checked the codes on my stang and got a 31. what does this mean and how do i fix it?

Thanks!

 

[Daggar]

Here... I'll link you to the one I just ordered.

http://www.maximummotorsports.com/cq.asp

 

[Killerrobotjews]

Here... I'll link you to the one I just ordered.

http://www.maximummotorsports.com/cq.asp

Cool, will i need a new cable with it?

 

[Killerrobotjews]

err sorry, if i buy the whole clutch kit, i should be set right?

 

[Killerrobotjews]

Alright, so if i order MMCP-51 the cables universal and will work in my '90 correct?

 

[Killerrobotjews]

Anyone have an answer for the code problem?

 

[Daggar]

yes... get the whole kit with the universal cable. It's already modified and ready to be installed.

 

[Killerrobotjews]

yes... get the whole kit with the universal cable. It's already modified and ready to be installed.

Awesome, Just ordered it Thanks!

 

[jrichker]

CODE: 31 (KOEO) - EVP circuit below minimum voltage. Vref (5 volt reference voltage supplied by the computer) missing or broken wire or bad connection in circuit. Use a DVM to check for 5 volts on the orange/white wire. If it is missing, look for +5 volts at the orange/white wire on the TPS or MAP sensor located on the firewall near the center of the car. Use the black/white wire for the ground for the DVM.

With the sensor removed from the EGR and still connected, press the plunger and watch the voltage change on the brown/lt green wire. Pull the passenger side kick panel and measure the voltage at the computer. You will need to remove the plastic cover over the wires and probe them from the backside. A safety pin may prove very useful for this task. Use pin 27, EVR input (brown/lt green wire) and pin 46, signal ground (black/white wire) to measure the voltage. The orange/white wire is Vref and should always be 5 volts -/+ .25 volt. Be sure to measure Vref at the EGR sensor to rule out any broken wires or bad connections.

 

[Killerrobotjews]

CODE: 31 (KOEO) - EVP circuit below minimum voltage. Vref (5 volt reference voltage supplied by the computer) missing or broken wire or bad connection in circuit. Use a DVM to check for 5 volts on the orange/white wire. If it is missing, look for +5 volts at the orange/white wire on the TPS or MAP sensor located on the firewall near the center of the car. Use the black/white wire for the ground for the DVM.

With the sensor removed from the EGR and still connected, press the plunger and watch the voltage change on the brown/lt green wire. Pull the passenger side kick panel and measure the voltage at the computer. You will need to remove the plastic cover over the wires and probe them from the backside. A safety pin may prove very useful for this task. Use pin 27, EVR input (brown/lt green wire) and pin 46, signal ground (black/white wire) to measure the voltage. The orange/white wire is Vref and should always be 5 volts -/+ .25 volt. Be sure to measure Vref at the EGR sensor to rule out any broken wires or bad connections.

So code 31's not a critical problem right?