Hey have any of you guys installed a Hyraulic Clutch kit from CNC.. I have a T-5 transmission and did this setup...
At first I could not bleed the slave cylinder, but after hours of tring I finally did it...... However I know have a nasty noise comming from the transmission it sounds like the Throw out bearing and when I engage the clutch it goes away,, and when I put it in reverse it clicks like its not adjusted properly... The Transmission and all the componets are rebuilt or new.
Need some advise if someone know what to do.....
At first I could not bleed the slave cylinder, but after hours of tring I finally did it...... However I know have a nasty noise comming from the transmission it sounds like the Throw out bearing and when I engage the clutch it goes away,, and when I put it in reverse it clicks like its not adjusted properly... The Transmission and all the componets are rebuilt or new.
Need some advise if someone know what to do.....