Cobra blower on a MACH 1

[mustanggt3685]

This isn't the usual cobra blower on a GT thread! I have a line on a used 03/04 cobra blower (eaton I believe?). I'm pretty sure it would fit the actual engine itself, as it is essentially the same thing- terminator heads and all. My concern is about clearence. Would I have clearence issues being that my mach has a shaker hood? Has anyone else on here tried this? I figure this would be worth a shot as it would still be well within range of a no hassle DD and it would be ALOT cheaper than a centri. Just curious...

 

[Saleen311]

it should fit under the hood. ive seen KBs under the shaker. as for the actual working i dunno.

 

[Mach1Run]

Check mach1registry for more info, seems like the topic comes up fairly regularly there.

 

[65fastback2+2]

it works fine, fits under the shaker and works fine, it is a bigger swap than most people think however

 

[Uncle Meat]

it works fine, fits under the shaker and works fine, it is a bigger swap than most people think however

+1. There are a LOT of little extras required to make this work and many of those extras are kept by the original Eaton owner because they are needed to support whatever they replaced the stock blower with!

U.M.