Hey I'm building an 86' 5.0 engine to drop into my 1970 stang. This is my combo-
Bored block .30 over
TFS Twisted Wedge almn. heads, TFS roller rocker arms w/ screw in studs
Keith Black flat top pistons
E303 cam w/ roller lifters
Edelbrock RPM Performer (or) Edelbrock Victor Jr. intake (havnt decided yet)
600 cfm holley 4bbl double pumper
Mallory Performance ignition
8mm Taylor plug wires
Anyone know if this is a good combo for a low end torque-producing motor for the street? For the most part i just need to know if the cam and heads will work together well, along with either of the Edelbrock intakes with the TFS heads. Thanks for your input!
Bored block .30 over
TFS Twisted Wedge almn. heads, TFS roller rocker arms w/ screw in studs
Keith Black flat top pistons
E303 cam w/ roller lifters
Edelbrock RPM Performer (or) Edelbrock Victor Jr. intake (havnt decided yet)
600 cfm holley 4bbl double pumper
Mallory Performance ignition
8mm Taylor plug wires
Anyone know if this is a good combo for a low end torque-producing motor for the street? For the most part i just need to know if the cam and heads will work together well, along with either of the Edelbrock intakes with the TFS heads. Thanks for your input!