Come list your planned modifications for the winter....

[nmcgrawj]

Just what it says...just wanna see what guys got planned:SNSign:

I'll start. After a lot of debating i finally made up my mind.


-408w
-new front bumper
-spoiler(xenon or s281...cant decide)
-And i would like a bullit grill


Those are the major things...i want new front seats but that wont happen. Also a paint job...but that wont happen either.


LETS HERE IT!

 

[CManT1914]

200 amp alternator! I already have it. I just gota put it in tomorrow.

 

[Grn92LX]

I wanna do 4.30 gears, 31 spline axles (lightened) 31 spline fms posi, all new bearings and seals with a girdle.

 

[urban96]

panhard bar
sub frames
LCA's

 

[1slow95]

My main goals for the winter are

1. Tune!!
2. Fix the suspension(tubular K-member/coil overs, tie rod ends, alignment, SFC's)
3. TKO600 swap

 

[Dan95-5.0]

**** man. where to begin.

-255 intank pump
-make and install battery relocation in trunk
-finish getting the heads ready
-install my ported heads/typhoon intake/2031 cam along with the stuff that goes with it like 70mm TB, timing chain etc.
-polish up some stuff or get chromed
-mold and paint engine bay
-once its running a dyno tune

that should be it i think

hopefully a new rear bumper and a xenon spoiler if i'm a good boy LOL

 

[bimmertech]

blower--on jsut finishing crap up
T56/already have clutch and stuff--hopefully by new years
dyno tune after tranny
00 cobra r recaro's
full length sfc's
new carpet/massive amounts of dynamat/gauges/paint interior
then start buildup of new shortblock

 

[NastE50]

331 AFR 185's etc.
C4 Automatic w/ 3000 Stall
PMS system
(twin turbo HOPEFULLY)

 

[rustang94]

black fr500s deep dish in the rear
smoked head lights
springs

 

[94GTLaserRC]

Some More chrome...put on my Polished Master cylinder.
RC

 

[blksn955.o]

re-doing my valvetrain geo. getting the proper pushrod length. Getting the 1.7 crane rr's setup at this time as well.

while its apart getting my eng. brackets powdercoated silver, and repainting my explorer intake silver along with my water pump and timing cover they are grey. Also repainting my fox valve covers black and silver instead of the black and grey they now are.

Installing my painted 99+ calipers and painting my rear calipers to match.

install some eurothane bushings in a set of stock upper controle arms that I will also box in, along with installing some euro bushings on the rear housing.

---right now the upper intake is off, brackets are ready to come off, going to drain the antifreeze in the morning and pull the lower intake and timing cover as well as vavle covers and of course the brackets.

Hope to get the brackets smoothed out and ready to be powder coated by next weekend and have the gaskets to put it together next weekend. but will not have the intake back on until I order/receive the pushrods.

 

[nmcgrawj]

331 AFR 185's etc.
C4 Automatic w/ 3000 Stall
PMS system
(twin turbo HOPEFULLY)

Is all that going into the stock block?

 

[mricci]

So far i already have and need to install
Lowering springs
Fox Throttle Body Conversion
New Built Tranny
X-pipe
Headers
100 shot NOS

Hopefully getting
full length subframes
A tune so i can use the nitrous
New paint and body kit in the spring

 

[1994Vib.RedGT]

Thumper E7s
Cam
24# inj
75mm Pro-m
Kirban AFPR
Pulleys

 

[95strokerPSU]

I just finished installing my new rear, so next...

-4 point roll bar from Rhodes Custom Auto
-Recover rear seats to match Corbeau fronts
-Engine dress-up
-Possibly a fox style throttle body swap

 

[Blackened302]

1) install body kit / body work
2) Papapapapaint!!!
3) clutch quadrant, FWA
4) headers, h-pipe

 

[Green 94 5.0]

the only thing i have planned for my car this winter, is to DRIVE it as much as possible. sorry.....couldnt resist rubbing that one in. it was a very chilly 68 the other night, but is back in the high 70's today. on a serious note , the new motor and tko600 may be finding their way into the car by february. that has nothing to do with the seasons though.

 

[GTS347]

I have several mods in the works for winter...
Wolfe Racecraft cage and subframes
proactive front suspension with K-member
Coil-over conversion for the rear
Performance Automatic C4
Quality driveshaft
Install Welds and new rubber all around

 

[Grn92LX]

I have several mods in the works for winter...
Wolfe Racecraft cage and subframes
proactive front suspension with K-member
Coil-over conversion for the rear
Performance Automatic C4
Quality driveshaft
Install Welds and new rubber all around

Do you have a 347 like your screen name says? If so, whats your combo? Any numbers?

 

[95riosnake]

My budget is pretty tight this year:

Lower 1.5"
1.25" spacers for the rear wheels
New set of 275/40/17 BFG T/A KDW's

and probably take things off then strip them and repaint, as I'm sure you all know I do quite often lol.