Confused about clutch pedal assembly wiring??

[jd-hart]

I am doing a AOD to 5sp swap.

I just received my clutch pedal assembly. On the side of the clutch pedal I have one gray connnector that looks like it has two slots for connectors in it.

On the brake pedal side, I also have a small connector. (Not the connector that attaches to the brake pedal)

I think I found the connector under the dash, it is a connector with another connectory plugged in that just makes a loop.

I am confused on what goes where, and if I need anything else.

Help would be great.
Thanks

 

[tmoss]

That loop is for automatics. Fro 5 spd cars, that loop plug is removed and you install a clutch interlock switch on the clutch arm so that the car will not start unless the clutch is disengaged. Put it in - it's a safety feature. Wiring schematics can be found at www.veryuseful.com/mustang/tech/engine

 

[HISSIN50]

I would also note that IIRC, there is a second switch on the clutch arm for the CC (so when you depress the clutch pedal, the CC disengages). Might want to retrofit that if you have CC.

Good luck.

 

[tmoss]

That is correct Hissin........I'd do them both!

 

[jd-hart]

thanks guys.

On the clutch netural swith, there looks like there is a place for two plugs. Once I unplug the loop connector, I can connect that harness to one of the plugs. Is that all I need to do? What about the other spot?

Is there any harness for the Cruise Control or do you just have to splice into it? Thanks

 

[tmoss]

Here is the clutch switch......

 

[tmoss]

And here is the cruise switch.........

 

[jd-hart]

Okay, I'm with ya.
So....the clutch swith will have one empty opening? What is it used for?

I can deal with the Cruise later, right? What is the cruise wired into on a factory 5-speed?