I just had a local shop install the following:
The car feels great, very tight, and the 60,000 mile squeaks and creaks are gone...HOWEVER, I have a couple of issues:
Thanks,
Chris
- Koni yellow single adjustable shocks and struts
- Steeda X2 balljoints
- Steeda Bumpsteer kit
- End Links
- Urethane front Control Arm bushings
The car feels great, very tight, and the 60,000 mile squeaks and creaks are gone...HOWEVER, I have a couple of issues:
- There is a dead spot that's about an inch or two wide in the center of the steering wheel. It was never there before so either these parts, the installation process, or the alignment is causing this issue. Any advice? I read over the instructions for the bumpsteer kit and it's not a simple RNR, so I have to wonder if they installed it properly.
- Also, the Driver's side strut won't adjust - it simply won't turn at all. The other's turn very easily. I crack the plastic adjuster and then even tried a pair of vise grips, but it still won't break free. Has anyone had this issue and if so were you able to fix it? I'm assuming that it's either defective or the shop used an impact wrench to install it - the instructions specifically state to use hand tools (on the top) otherwise you can jam the adjuster. I've ordered a new one and will have the shop RNR and then I'll return the original strut.
Thanks,
Chris