Difference between fox and sn95 headers?

[fastas69]

Does anyone know what the difference between the Fox 5.0 headers and the SN95 headers is? Is it just the tube for the smog or what?

 

[Labora]

Try a search.

 

[Adam95GT]

SHorties just the egr bungs...... Long tubes.... hit the clutch fork..

 

[99FiveOh]

If this is true, then why couldn't I use a Fox H Pipe on my 94? I went to order one and they were out of stock on 94/95 H pipes, so I asked if a Fox one would work and they said it would not. Something about the collector flange being in a different spot.

No hijack intended...sorry

 

[nmcgrawj]

h pipe for shortys?????



And also this depends on what company you speak of. Not every company uses the same primary tube "paths" for the design of their long tubes. Accufab for instance uses a design that will work on fox and 94-95's....but mac wont. The clutch fork comes out of the 94-95 bellhousing at a different "time"...call it 7 o'clock...where as the fox is 9 o'clock.


So it depends. Your best bet is to search.

 

[ProKiller]

i got fox bbk long tubes and they fit.

 

[madams74]

I purchased Fox GT40 P headers from Ford Motorsports. They fit great, but I will have to have custom exhaust work done up to the header flange.

 

[revhead347]

If this is true, then why couldn't I use a Fox H Pipe on my 94? I went to order one and they were out of stock on 94/95 H pipes, so I asked if a Fox one would work and they said it would not. Something about the collector flange being in a different spot.

No hijack intended...sorry

Not sure about the collector flange, but I know the hangers are different.

Kurt

 

[99FiveOh]

i got fox bbk long tubes and they fit.

when you say fit, do you mean they went in without a hitch or they went in with some work?

 

[Chern_889]

I purchased Fox GT40 P headers from Ford Motorsports. They fit great, but I will have to have custom exhaust work done up to the header flange.

My SN-95 offroad H-pipe bolted right up to my FMS GT40P headers with great fitment, just like stock. Dont know why you would need to get custom work done

 

[ProKiller]

when you say fit, do you mean they went in without a hitch or they went in with some work?

they fit....

took a while to get them in but they fit. didn't have to break or relocate anything but it was a bear getting the passenger side in there.

 

[99FiveOh]

I'll put them in when I drop my new motor in, so they should be cake then.

 

[fastas69]

I was looking at a set of BBK equal length headers of a fox 5.0 for my 95

 

[Chern_889]

I was looking at a set of BBK equal length headers of a fox 5.0 for my 95

Dont waste your time, from what ive read they arnt worth the headaches. They only make a minimal power difference. And im thinking that you will have serious issues trying to get the foxbody ones in your SN

 

[cody50]

I just put a set of MAC 94 351 headers in my '94 and they went alright (put em in from the bottom) The drivers side is right up against the inspection cover for the shift fork on my trans though.