I have purchase the below components from branda. The red Light bezel, Aluminum frame, light buckets and the fiber glass Back Panel have all been assembled. Basically I have the lights installed in the panel, ready for installation into the car. What I cannot figure out is.....
1) How the panel, if supported by rivets is going to hold the lights up?
2) What I am suppose to do with the taillight box housings? i.e. how is it installed?
3) Where does the gasket go?
ANY HELP WOULD BE APPRECIATED!
Tailight Panel: http://www.cobranda.com/19shtapa1.html
1967 Shelby Taillight Frames http://www.cobranda.com/19shtafr.html
1967 Shelby Taillight Box Housings http://www.cobranda.com/19shtaboxho.html
1967 Shelby Taillight Lense http://www.cobranda.com/19shtale.html
1967 Shelby Taillight Frames http://www.cobranda.com/19shtafr.html
1) How the panel, if supported by rivets is going to hold the lights up?
2) What I am suppose to do with the taillight box housings? i.e. how is it installed?
3) Where does the gasket go?
ANY HELP WOULD BE APPRECIATED!
Tailight Panel: http://www.cobranda.com/19shtapa1.html
1967 Shelby Taillight Frames http://www.cobranda.com/19shtafr.html
1967 Shelby Taillight Box Housings http://www.cobranda.com/19shtaboxho.html
1967 Shelby Taillight Lense http://www.cobranda.com/19shtale.html
1967 Shelby Taillight Frames http://www.cobranda.com/19shtafr.html