DOHC Swap

68FBJJZ109

Member
May 2, 2005
357
0
17
Easton, PA
Prob not the Ideal section to ask. But has any one here swapped a mod motor more specifically a DOHC motor into there fox. I am researching it on modularfox.com, just wondering if any one here has done it. Thanks
 
I was highly considering doing in for my wifes show car notch that I am going to start building. After weighing out all the differences I decided to go with a turbo small block. The biggest issue I see if the wiring, but a DFI or anytype of engine managment system can take care of that, k-members are available from a lot of vendors do as well... It's tight but it can be done and it does catch the eye when the hood is opened.
 
There have been multiple issues of MM&FF mag and 5.0 Mustang magthat have covered this. I saw a 5.4L SOHC swap, an 01 Cobra 4.6L DOHC swap, and an 03 Cobra 4.6L DOHC cam swap. It looked quite involved since they started from scratch. I would look for an entire car, and get it all still in tact and in stock form. A little easier to talk about than to hunt down though.
 
Well ModularFox. has alot of great info. included some great pics, apparently you can squeeze just about anything into a fox. The have a Turbocharged DOHC 5.4 stuffed into a notch. I should have most of the wiring harnesses by the end of the week from the multple mark VIII''s there