Hey guys ordered koos long tube,x pipe(offroad) pypes midmufflers,steeda udp,cmvp, 4.10's gears,hurst short throw shifter,changing all fluids to royal purple(motor,tranny,rear).I already have sct2 tune by Brenspeed with Demolet cold air kit.My car is 2007 Mustang GT/CS with 5 speed manual,My question is how much power should I make when everything is completed.I am going to have it dynoed tune when completed.I had Brenspeed send me a custom tune for all the parts listed.......Thanks..
Dynoed Tune!!!!!!!!!
- Thread starter 87fcoupe
- Start date
Wow all that money spent all he is going to get is about 40 extra hp to the wheels. He should just spray and be done with it.
60~ hp. These cars only put down around 260ish to the wheels bone stock. Seems like a pretty good gain for what he paid to me.
I've seen S197's put down anywhere from 245 to 260 bone stock, so yeah, 320 would be just about right.
Mr_Q
Founding Member
HAHAHA, come on! That's not that bad and far safer, always available power. I'm not against spray but it's no where near the same for daily driving as bolt ons.
Besides...you want expensive with little or NO gains....when I had my 350z....1000s and 1000s spent all for 11hp!!!! ELEVEN.
I hope you are right...Been told probally 320's to 330's range(rwhp)..Post results when completed..........
Cerwindel
New Member
Yeah i usto have a 350z as well , cost me 1500 bucks for around 10rwhp... Wasnt worth it at all..
Now I got my mustang and.....
TI Intake, Mobil 1 Fluids, Steeda Pullies, SCT2 Brenspeed 91octane tune, and pypes violator Axle backs..
Total cost of all mods.. 1,000$
Total Gain - 45RWHP
Dyno - 309 RWHP
Not bad.... ?
lightblade
Member
- Aug 7, 2004
- 366
- 0
- 17
I have almost the exact same mods, made 303rwhp on a 95 degree day with the stock axleback. My guess is around 310rwhp
"Yeah i usto have a 350z as well , cost me 1500 bucks for around 10rwhp... Wasnt worth it at all..
Now I got my mustang and.....
TI Intake, Mobil 1 Fluids, Steeda Pullies, SCT2 Brenspeed 91octane tune, and pypes violator Axle backs..
Total cost of all mods.. 1,000$
Total Gain - 45RWHP
Dyno - 309 RWHP
Not bad.... ? "
Yes, totally BAD! These cars should have that from the factory! Ford is so tight
Now I got my mustang and.....
TI Intake, Mobil 1 Fluids, Steeda Pullies, SCT2 Brenspeed 91octane tune, and pypes violator Axle backs..
Total cost of all mods.. 1,000$
Total Gain - 45RWHP
Dyno - 309 RWHP
Not bad.... ? "
Yes, totally BAD! These cars should have that from the factory! Ford is so tight
