edelbrock 4.6 victor jr.?

tank_567 · Aug 10, 2009

http://www.stangnet.com/mustang-forums/721403-edelbrock-manifold-finally-released.html
That intake has seen a 30-60rwhp boost on turbo and other boosted cars Your not going to really make any power with it n/a unless you have some badass heads and cams.

98COBRA281 · Aug 10, 2009

tank_567 said:
Your not going to really make any power with it n/a unless you have some badass heads and cams.

well i realy dont know how good my heads are, but i think they flow pretty well considering im over 300rwhp..........

blubullett · Aug 10, 2009

tank_567 said:
http://www.stangnet.com/mustang-forums/721403-edelbrock-manifold-finally-released.html
That intake has seen a 30-60rwhp boost on turbo and other boosted cars Your not going to really make any power with it n/a unless you have some badass heads and cams.

Thats what im saying. Get some stage3 cams and it might help. You already have nice internals so you can rev it. I bet you will still loose power till 5 grand though.

y2k02 · Aug 10, 2009

Tim2002GT said:
What kind of clearancing did you have to do for the stock hood? Those are some nice tq gains!

I'll post a pic tomorrow. My car is making 554rwtq with 10psi through the C4 transmission.

Green&GoldGT · Aug 11, 2009

98COBRA281 said:
well i have been doing some searching, and im 99% sure im going to stay all motor, and do the following

4:30's in the rear
edelbrock intake(maybe do some light porting on it)
mmr adapter plate
mmr fuel rails
jlt ram air intake
90mm lighting MAF
port C&L upper plenuim

and retune and shoot for 330+rwhp, 6500 rpms, and low 12's with some more suspension work, out of an all motor NPI!

Why not just buy Trick Flow heads and bump your CR at the same time for the price of all those mods. Besides the Edelbrock ports match up to PI heads. I dont see you making 330 without more compression if you want to stay NPI. I would also suggest an aluminum flywheel.

98COBRA281 · Aug 11, 2009

Green&GoldGT said:
Why not just buy Trick Flow heads and bump your CR at the same time for the price of all those mods. Besides the Edelbrock ports match up to PI heads. I dont see you making 330 without more compression if you want to stay NPI. I would also suggest an aluminum flywheel.

TF heads cost $1800, i have about $600 in my heads, with valves /valve job / guides, springs, porting and resurfacing...

my compression is already over 10:1, its about 10.2:1, my heads are ported to match pi intakes,(i can post pics) and aluminum flywheel and drive shaft are coming, but i dont what to buy anyhthing until i decide on a tranny, im prolly going with a tko500, and its only 20rwhp i have to gain

edelbrock 4.6 victor jr.?

tank_567

Active Member

98COBRA281

blubullett

Member

y2k02

Member

Green&GoldGT

Member

98COBRA281

Similar threads

edelbrock 4.6 victor jr.?

tank_567

Active Member

98COBRA281

blubullett

Member

y2k02

Member

Green&GoldGT

Member

98COBRA281

Similar threads

Privacy & Transparency

Privacy & Transparency