• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

engine hot after 70 MPH

  • Thread starter Thread starter LaserSVT
  • Start date Start date Jun 18, 2007

LaserSVT

Got FB banned again for saying nards
Founding Member
Nov 29, 1999
9,402
3,548
233
Jun 18, 2007
#1
  • Jun 18, 2007
  • #1
Another stupid question, when going above 70 mph longer than 10 min my car gets hot with the A/C on, not over heating, just hotter than I want to see. When I get into town it cools down right away. I have a new copper two row radiator, pump looks fairly fresh with no bearing noise, new rad cap, new thermostat (third one, I tried 196, 160, and finally a 180 mr gasket, I even tried no thermostate) no leaks. My fan is stock but seems to spin too freely and if I push on the throttle to2-3k rpm the fan does not appear to move much faster, could it be a worn fan clutch? Help this thing is driving me nuts!
 

Nibbie

New Member
Mar 10, 2007
127
0
0
Jun 19, 2007
#2
  • Jun 19, 2007
  • #2
If you have a fan driven by the water pump then at 70mph it should not spin as fast as it would when your cruising in town. You need good airflow to your radiator, make sure there is nothing blocking or obstructing the hols and such on the front end (car bra/billit grill). Do you still have the fan shroud that will direct the cool air toward the center of your radiator? Is the little air dam under the front fascia still there? that will also direct airflow toward the top of the radiator. Hope that helps. oh and your fan clutch should have some sort of resistance in it. that could also be worn, but if it was worn i would think it would cause more of a problem for you just cruising because it wouldnt turn as fast as it could because the clutch would always be slipping.
 

LaserSVT

Got FB banned again for saying nards
Founding Member
Nov 29, 1999
9,402
3,548
233
Jun 19, 2007
#3
  • Jun 19, 2007
  • #3
I do not have a deflecto or anything under the front of my car (ie no black plastic panel between the front spoiler and under the radiator) is there supposed to be something there, and if so where do I get one from?
 

HISSIN50

"How long does it take to get help in here?
15 Year Member
Nov 29, 1999
31,179
34
129
Jun 19, 2007
#4
  • Jun 19, 2007
  • #4
As suggested, forget about anything involving the fan - it's not an issue.

Once the air dam is installed (they are like 15 bucks at the dealership IIRC), if it still runs hot at speed and there is no known debris in front of the radiator, consider that the radiator simply cannot reject enough heat under the load of being at speed. The air dam really should help in your hot Texas heat.


Good luck.
 

LaserSVT

Got FB banned again for saying nards
Founding Member
Nov 29, 1999
9,402
3,548
233
Jun 19, 2007
#5
  • Jun 19, 2007
  • #5
will the air deflector for the top of the radiator hel too? I see them for sale all over.
 

Nibbie

New Member
Mar 10, 2007
127
0
0
Jun 19, 2007
#6
  • Jun 19, 2007
  • #6
Not sure, never used one, I still use my original fan shroud that directs the air through the radiator and to the engine. If its cheap it wouldnt hurt to try it.
 

LaserSVT

Got FB banned again for saying nards
Founding Member
Nov 29, 1999
9,402
3,548
233
Jun 19, 2007
#7
  • Jun 19, 2007
  • #7
I still have the factory fan shroud on the car, is that the same thing as the air dam, or something else entirely?
 

LaserSVT

Got FB banned again for saying nards
Founding Member
Nov 29, 1999
9,402
3,548
233
Jun 19, 2007
#8
  • Jun 19, 2007
  • #8
Ok I see the problem. I found the part online, but where it mounts is mangled from an old accident. So do you think a cobra grille insert would help?
 

HISSIN50

"How long does it take to get help in here?
15 Year Member
Nov 29, 1999
31,179
34
129
Jun 19, 2007
#9
  • Jun 19, 2007
  • #9
The grill idea would help (as an alternative, Monte Smith has a write-up on his site or has posted how he did his before - it was a custom thing done with a hole saw IIRC). That said, it is not requisite IMHO (I'm a fellow desert dude - So. AZ for me).

The air dam not only helps direct air towards the front of the radiator but also creates a low pressure area behind the radiator (helping draw air through the coil).

You should be able to rig the air dam onto your car - it isnt heavy. I've had to do that before on another stang and it wasnt bad. I used machine screws and nyloks with my own brackets to hold it on.

Good luck.
 

LaserSVT

Got FB banned again for saying nards
Founding Member
Nov 29, 1999
9,402
3,548
233
Jun 19, 2007
#10
  • Jun 19, 2007
  • #10
Thanks I will give it a shot. Probaly drive down to Texas Mustangs and pick one up, should be able to figure out how to atatch it to my mangled rad support.
 

LaserSVT

Got FB banned again for saying nards
Founding Member
Nov 29, 1999
9,402
3,548
233
Jun 23, 2007
#11
  • Jun 23, 2007
  • #11
FIXED!!! Thanks guys for the help. First part I replace was the fan clutch with one from Latemodel Restoration, big difference, nice unit. Now I can hear the fan at higher RPM and it is really moving air. I kept at 90 for 9 or 10 miles and it never even hit halfway on the gauge. Then my air dam showed up, now with that installed it stays downright cold Right Arm everyone!
 

Mustang5L5

That is…until I whipped out my Bissell
Mod Dude
Feb 18, 2001
43,374
18,121
224
Massachusetts
Jun 24, 2007
#12
  • Jun 24, 2007
  • #12
Amazing how a simple little peice of plastic can make that much of a difference.
 
You must log in or register to reply here.

Similar threads

Engine Themostat
  • Mindseye007
  • Jan 30, 2026
  • Fox 5.0 Mustang Tech
  • 2
Replies
21
Views
1K
Fox 5.0 Mustang Tech Feb 1, 2026
86HO5.0
8
M
Resolved 1988 Foxbody - Overheating Summer
  • MDrisc
  • Oct 26, 2025
  • Fox 5.0 Mustang Tech
Replies
16
Views
1K
Fox 5.0 Mustang Tech Jul 17, 2026
fasterthangas
F
Engine Engine Bay crazy hot!
  • R82148V
  • Aug 28, 2023
  • Fox 5.0 Mustang Tech
Replies
15
Views
6K
Fox 5.0 Mustang Tech Aug 30, 2023
Mustang5L5
For Sale 3-owner 1987 Mustang GT, $18K obro, Lancaster CA
  • Bill Cool
  • Oct 6, 2024
  • Fox Body Mustangs For Sale (1979-93)
Replies
4
Views
2K
Fox Body Mustangs For Sale (1979-93) Oct 13, 2024
nickyb
3
Engine running warm/hot...stumped
  • 347notch89
  • Sep 19, 2021
  • Fox 5.0 Mustang Tech
Replies
12
Views
2K
Fox 5.0 Mustang Tech Sep 21, 2021
2000xp8
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?