Engine idea

WilwoodFiveO

Member
Oct 20, 2005
108
0
16
VA
hey guys i need some advice are any of you guys running tell me how they run if you are


these heads http://www.fordracingparts.com/parts/part_details.asp?PartKeyField=5152

and this intake manifold http://www.fordracingparts.com/parts/part_details.asp?PartKeyField=7816

also this would be used with the stock block, i would also like to know everything else needed to get the most performance out of my stock block (stroker, MAF, with above a Throttle body, $hit like that) i would like to go NA. so could you please tell me everything to get my HP and Torque #'s up into the high 300's or 400's
 
1200 for a single head? thats pretty damn expensive. check out AFR, trick flow twisted wedge, or edelbrock. even canfield if u want to go big bucks. and check out the edelbrock airgap lower (carb) intake.
 
Holy Chit! Those are full-blown NASCAR spec race heads for a 800hp 8000RPM monster, not something with a stock block!
A set of AFR185s, a 331 kit, a good cam (custom?), Performer intake (or maybe Explorer?) should get about 330RWHP & 340RWTQ if not more

PS I have a dyno sheet for a 331 with a PerfRPM intake, 750 Holley, mild solid roller, AFR185s that dynoed at 402hp/395tq and 323/335 @ the wheels. They found out later that the tune was off, and expect ~345rwhp tuned :D Not bad for something the guy drives to work!
 
does anybody know what block would be good with those heads and intake manifold i really like those now that i have seen that. what else do i need to make my car a beast like nascars ( it doesn't need to have 800 hp but maybe 450-550 that would be nice! ) can you guys give me some ideas on that