Engine not happy

[CobraRed_96_GT]

I am always afraid of these threads, how do people motors get in this shape.

They notice they've crossed the edge when they start losing to RSX's

 

[Winters98GT]

Please effing ban me. I beg you. I have learned in the past few months that this site is worthless. I just hope god can for give me for forgetting a thread on a worthless forum. Better yet please tell me how i can delete my account

and this guy is still around

 

[myponyrocks]

and this guy is still around

And wants serious help...

How does that story go about the crying boy and wolves?

 

[FordTard]

and this guy is still around

STFU

Apparently you cannot read or were to busy drooling on a dick to finish reading the thread, because I clearly explained what happened. So get off my case and quit effing crying about it

Anyway...

Since I have had the car [3 years now] I have taken great care of the engine and the trans, but I cannot say the same about past owners. I know the car sat for about 2 years and regular maintenance was neglected.

 

[Winters98GT]

STFU

Apparently you cannot read or were to busy drooling on a dick to finish reading the thread, because I clearly explained what happened. So get off my case and quit effing crying about it

Anyway...

Since I have had the car [3 years now] I have taken great care of the engine and the trans, but I cannot say the same about past owners. I know the car sat for about 2 years and regular maintenance was neglected.

Well, I could care less about your sad automobile situation. Just found it ironic that you bash the site, then ask for help. Good luck.

 

[LaserSVT]

Mabey you should try rinsing out the engine. Sometimes a good motor flush will help remove oil deposits that make the valves stick and cause bearing failure.
What you do is drain all the oil and leave the drain plug out. Then you stick a garden hose on the oil fill and turn it on just a little bit. Dont crank it open as too much water will cause dammage. Then start the engine and let it idle for 10-15 minutes. Should clear it right up

 

[mazen189]

Mabey you should try rinsing out the engine. Sometimes a good motor flush will help remove oil deposits that make the valves stick and cause bearing failure.
What you do is drain all the oil and leave the drain plug out. Then you stick a garden hose on the oil fill and turn it on just a little bit. Dont crank it open as too much water will cause dammage. Then start the engine and let it idle for 10-15 minutes. Should clear it right up

WTF???

 

[98COBRA281]

Mabey you should try rinsing out the engine. Sometimes a good motor flush will help remove oil deposits that make the valves stick and cause bearing failure.
What you do is drain all the oil and leave the drain plug out. Then you stick a garden hose on the oil fill and turn it on just a little bit. Dont crank it open as too much water will cause dammage. Then start the engine and let it idle for 10-15 minutes. Should clear it right up

, i remember a guy came on here and said he did that..lol

 

[281CI96Coupe]

Mabey you should try rinsing out the engine. Sometimes a good motor flush will help remove oil deposits that make the valves stick and cause bearing failure.
What you do is drain all the oil and leave the drain plug out. Then you stick a garden hose on the oil fill and turn it on just a little bit. Dont crank it open as too much water will cause dammage. Then start the engine and let it idle for 10-15 minutes. Should clear it right up

 

[Omars96GT]

OMG..... im going to try that out right now to see if i gain any more hp due to oil deposits that make the valves stick and cause bearing failure lol

 

[FordTard]

Thanks guys. will do.

 

[COramprat]

Start over.