They notice they've crossed the edge when they start losing to RSX'sI am always afraid of these threads, how do people motors get in this shape.
Please effing ban me. I beg you. I have learned in the past few months that this site is worthless. I just hope god can for give me for forgetting a thread on a worthless forum. Better yet please tell me how i can delete my account
and this guy is still around
and this guy is still around
STFU
Apparently you cannot read or were to busydrooling on a dick to finish reading the thread, because I clearly explained what happened. So get off my case and quit effing crying about it
Anyway...
Since I have had the car [3 years now] I have taken great care of the engine and the trans, but I cannot say the same about past owners. I know the car sat for about 2 years and regular maintenance was neglected.
Mabey you should try rinsing out the engine. Sometimes a good motor flush will help remove oil deposits that make the valves stick and cause bearing failure.
What you do is drain all the oil and leave the drain plug out. Then you stick a garden hose on the oil fill and turn it on just a little bit. Dont crank it open as too much water will cause dammage. Then start the engine and let it idle for 10-15 minutes. Should clear it right up
Mabey you should try rinsing out the engine. Sometimes a good motor flush will help remove oil deposits that make the valves stick and cause bearing failure.
What you do is drain all the oil and leave the drain plug out. Then you stick a garden hose on the oil fill and turn it on just a little bit. Dont crank it open as too much water will cause dammage. Then start the engine and let it idle for 10-15 minutes. Should clear it right up
Mabey you should try rinsing out the engine. Sometimes a good motor flush will help remove oil deposits that make the valves stick and cause bearing failure.
What you do is drain all the oil and leave the drain plug out. Then you stick a garden hose on the oil fill and turn it on just a little bit. Dont crank it open as too much water will cause dammage. Then start the engine and let it idle for 10-15 minutes. Should clear it right up
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?