Engine runs for about 5 seconds

Sample36

New Member
May 8, 2006
0
0
0
Car ran perfect no issues...the fuel pump quit so i replaced it...this is when all the problems started...I jumped the fuel pump out to prime the system and i touched the wrong lead and had a few sparks.. i primed the sytem and started the car. Car started imediately and revved up to 1200rpm, leveled out at 1000rpm then quits. I thought it was a faulty fuel pump so I put another new one in with the same results. I hooked up the fuel pump direct still no improvement...any suggestions..:(
1988 5.0L Mustang
 
wow...sparks while putting in a fuel pump are not a good thing. i would have soiled my britches. dont really know what to tell you unless the relay is bad and when you turn the key to "start" it primes the fuel system but in "run" the fuel pump shuts itself off and it just uses up all the gas in the lines. kind of wierd actually, but thats the only thing i could think of. maybe someone who has had this problem can help out.
 
No upgrades just a new fuel pump.... I think when i touched the wrong leads together i screwed up the computer...i am buying a code reader tonight to see if i have any issues there
 
I'm not sure what you jumped or where, but check the fusible link (18 AWG IIRC) for the fuel pump.

You can also probe the FP relay socket during the priming and note the values. If you have three 12 volt terminals and one ground, you should be good.
If you're missing the common terminal current, the relay has nothing to pass to the pump (the link provides power to the common terminal).

Good luck.