• Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 V6 Mustang Tech

Engine Stalling! Check Engine Light Code P0302

  • Thread starter Thread starter steddibettey
  • Start date Start date May 24, 2005

steddibettey

New Member
May 23, 2005
5
0
0
Atlanta, Ga
May 24, 2005
#1
  • May 24, 2005
  • #1
OK HERE IT GOES. I AM NEW TO THIS SITE BUT HAVE FOUND ALOT OF HELPFUL INFO. FOR MY MUSTANG HERE. BUT I HAVE A MAJOR PROBLEM. BOUGHT THIS MUSTANG IN FEB., LOVE IT. RAN FINE UNTIL I TOOK IT TO GET MY WHEELS PUT ON. OH, 19' OZ ANTERAS, BTW. ANYWAYS, JUST HAPPENS THAT MY CAR "CHECK ENGINE LIGHT" COMES ON AS SOON AS I LEAVE THE PLACE. ALSO, JUST HAPPENS THAT 50% OF THE EMPLOYEES HAVE MUSTANGS. PLUS, WHEN I WAS CHANGING OUT MY SPARK PLUG AND WIRES I NOTICE THAT A PIECE OF MY HOSE IS MISSING THAT RUNS FROM MY INTAKE TO AIR FILTER HOUSING. ALSO IN FUSE BLOCK(ENGINE) THERE ARE LIKE 4 FUSES MISSING AND ONLY ONE RELAY. NOW I HAVE CLEANED THE MOTOR A FEW TIMES. I THINK I WOULD HAVE NOTICED ALL THE STUFF MISSING. SPECIALLY THE HOSE. ANYWAYS, FORGOT TO MENTION THE MOTOR. I HAVE A 95 MUSTANG LX W/ V6 SPLIT 3.8 & MANUAL TRANNY. IT'S SPUTTERING REALLY BAD LIKE IT'S CLOGGED UP SOMEWHERE. THAT'S WHAT IT SOUNDS LIKE ANYWAYS. ALL THIS COME OUT OF THE BLUE. THE A/C WON'T COME ON AND I'VE HAD IT FILLED RECENTLY. ALSO RUNNING HOT. I BROUGHT IT UP TO AUTOZONE AND THE CODE READERS SAYS P0302 LIKE 4 TIMES. SO I STAYED UP ALL NIGHT CHANGED OUT THE PLUGS AND WIRES B/C THAT'S WHAT THE CODE SAID. CYLINDER 2 MISFIRE. WENT FOR A TEST DRIVE THIS MORNING AND IT'S STILL RUNNING LIKE CRAP IF NOT WORSE. WHEN YOU GIVE IT GAS, IT SOUNDS LIKE A HOOPTY AND WHEN GO TO SLOW DOWN AND STOP FEELS LIKE THE MOTOR IS JUST GOING TO BLOW, IT SHAKES REALLY BAD. ANY ADVICE WOULD BE VERY MUCH APPRECIATED. JUST SOOOO FRUSTRATING. <---- THAT'S WHAT I FEEL LIKE ABOUT NOW. GWEN.
 

Attachments

  • IM001639.webp
    35.5 KB · Views: 361

marvinmycat

Founding Member
Feb 13, 2002
1,179
0
0
Buffalo, NY
May 24, 2005
#2
  • May 24, 2005
  • #2
Reconnect the hose, and figure out which fuses are missing.
 

steddibettey

New Member
May 23, 2005
5
0
0
Atlanta, Ga
May 24, 2005
#3
  • May 24, 2005
  • #3
Already did that.

That was the first thing i did. Sorry, forgot to put that in there. I still have some relays to put in, anyone have the fuse block layout? Like what supposed to go to what fuse? It's for a 95 mustang lx. v6 split 3.8. I really must get her back up and running asap. This is my everyday vehic. Thanks for the quick response. What about the coil pack itself? Think that could be causing the prob?
 

steddibettey

New Member
May 23, 2005
5
0
0
Atlanta, Ga
May 24, 2005
#4
  • May 24, 2005
  • #4
MAF or O2 sensor?

My mom has a Bonneville that kinda did the same thing. I beleive it was her MAF sensor. Possibly mine? Gwen
 

marvinmycat

Founding Member
Feb 13, 2002
1,179
0
0
Buffalo, NY
May 24, 2005
#5
  • May 24, 2005
  • #5
As far as the fuses go, isn't there a diagram on the inside of the fuse box cover?

Disconnect the battery for 30 minures, then get it up to 55mph+ for five minutes and see if it still throws the same code.

Coil pack could be bad as well, but it's better to start eliminating the possibilities before just replacing everything.

You could even have bad gas, who knows?
 
T

telmd

New Member
Jan 14, 2004
34
0
0
Jville, FL
May 24, 2005
#6
  • May 24, 2005
  • #6
I would pull the plug for that cylinder thats misfiring and check it out. See if its normal or wet. If it's running hot it could be a blown head gasket dropping a lil water in the cylinder causing it to misfire or could be what my prob was.

had the same prob with my 94. Ended up being my Computer being bad. Misfire was caused by injector recieving a constant signal from the brain and constantly dumping fuel. Got a new brain from the boneyard(unit had more miles on it than my car) and everything was fine for about 8 monthes then low and behold same thing. This time i went and bought a reman'd brain from autozone and all has been well since.

btw I have also replaced my head gaskets due to a failure and had none of the typical blown gasket syptoms other than every blue moon the temp would just rise like crazy stay there for awhile then drop...also my AC or Heater wouldnt work during those times. Replaced both gaskets and all has been well..
 

Stangfanatic98

New Member
Mar 30, 2005
139
1
0
Woodbridge, VA
May 24, 2005
#7
  • May 24, 2005
  • #7
If you're missing the hose that runs from the air box to your throttle body, you're car is running without a MAF, PCV sensor, and another sensor which I believe is the IAC. I bet getting some rubber bewtween the two will solve alot of problems, if not all. Then focus on that Cylinder 2 misfire.
 

steddibettey

New Member
May 23, 2005
5
0
0
Atlanta, Ga
May 27, 2005
#8
  • May 27, 2005
  • #8
Hey Thanx for the advice all!! LOTS OF STUFF HERE!!

Well I finally got it!! I changed the spark plugs, wires, oil, coilpack, belt, hoses, relays, etc. Just went ahead fixed it all and it runs better than EVER. No bs. It was my coil pack after all. But doing everything myself was a ******!! I would have it all fixed, go for a test ride and if I got on it, I would loose a cylinder. I was getting so pissed. This is the 3rd day under the hood. So, I finally found out what the problem was. When I installed the new coil pack, the rubber orange band for the connector/adapter was wedged up in the connector. So with both orange bands on it was backing out and would cause it to run like crap. But it sounds and runs soo much better!! Thanks for all the comments they really helped narrow it down. Was kinda glad though after I had fixed it. I must have read the Mustang repair guide at least 15 times front to back. So I learned alot about my car and next time I'll know what to do incase something like that happens again. I wanted to take the engine out and bring it in and clean it but I guess I'll wait. Just bought another project car yesterday. Got a 1979 Chevy Camaro with a 307(305 w/ heads bored over). Check out the pic. On my way to have the tint done. Hope you like the new pics below. If anyone is near Atlanta and ever just wants to go for a drive or race, let me know. Looking for other Mustang enthusiasts!! Here's my email genevieve@imabadlittlegirl.com Would love to find a club for the weekends.
 

Attachments

  • Fixing-car.webp
    42.3 KB · Views: 284
  • camaro.webp
    40.7 KB · Views: 306

zincyellow03

New Member
Jul 5, 2004
0
0
0
My dead ho likes Chicago
May 27, 2005
#9
  • May 27, 2005
  • #9
steddibettey said:
yellow, yellow/black interior, black widow body kit, saleen 19's special ordered(yellow)
Click to expand...

Good that your found your problem. You should join YMR (www.yellowmustangregistory.com)
 

steddibettey

New Member
May 23, 2005
5
0
0
Atlanta, Ga
May 27, 2005
#10
  • May 27, 2005
  • #10
Rims Are Gone

Wow. What were they on here for like an hour or two. Sold. Everything else still stands though.
 
You must log in or register to reply here.

Similar threads

P
Repeated P2004 DTC trouble code with no apparent symptoms
  • poehitman
  • Mar 11, 2026
  • SN95 V6 Mustang Tech
Replies
2
Views
193
SN95 V6 Mustang Tech Mar 12, 2026
poehitman
P
M
Bad PCM?
  • MrPuffels
  • Jul 22, 2026
  • 2005 - 2009 Specific Tech
Replies
0
Views
92
2005 - 2009 Specific Tech Jul 22, 2026
MrPuffels
M
Ford truck engine swap issues
  • keel
  • Jul 7, 2026
  • Other Auto Tech
Replies
17
Views
333
Other Auto Tech Jul 13, 2026
General karthief
A
Check Engine codes jumping around
  • azactor
  • Jan 9, 2026
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
1
Views
191
1996 - 2004 SN95 Mustang -General/Talk- Jan 10, 2026
gkomo
B
Engine Another no start after washing engine bay
  • bruno
  • Apr 26, 2026
  • Fox 5.0 Mustang Tech
  • 2
Replies
24
Views
738
Fox 5.0 Mustang Tech May 7, 2026
AeroCoupe
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 V6 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?