Exhaust Flowmaster Tailpipes

Y'all might look at Stinger's web page. He does sell tail pipes, though the site is mostly dedicated to the 2.3 4 cylinder crowd, I bought a set of tails from him for my GT. They aren't GT specific, they are LX pipes but they're easy to "convert"...by cutting a few inches off the ends of each side and putting a turndown on them. Fit pretty good for aftermarket pipes. 2 piece design (but mine are 3") so they slip over the axle housing easily. AND....cheaper than everyone else's. I think the site is something like stinger-performance dot com or something along those lines.

As far as putting them on your existing mufflers, that's an easy task. The only thing, you may have to adjust things around a little bit. IF it's already welded up, that "could" throw a wrench into the spokes depending on how the mufflers were positioned. On mine, everything was custom so I didn't have much trouble other than having to fabricate EVERYTHING from the headers back, then I tried stinger's tails and they fit VERY well with minimal trimming here & there, but again they're 3". I my case, the only regret is not putting a resonator or cats on, as the 427 barks pretty good even through the quietest 50 series flowmaster mufflers. Not real loud at idle, but when you get into the throttle it starts getting louder than I like. May put some cats on it at some point.