Front Control Arm Bushing Installation

89GTpwr

New Member
Feb 23, 2008
13
0
0
Hi,

I bought a set polyurethane bushing to replace my old ones with in my stock front control arms. I got the old ones pounded out okay. But the problem is that when using my shop press to put them back in i made the big mistake of not putting anything in between the spaces of the control arm, which has distorted it pretty bad, its probably about a half inch squished in. I am just wondering if it is at all possible to get the control arm back to the original shape, as i do still have the other side in which i could take measurements off. Is this at all possible? or am i better off just to go to the scrap yard and get another one and try all over again?

Any help is greatly appreciated.