• Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-

Future plans. Looking for advice.

  • Thread starter Thread starter Skidzz
  • Start date Start date Feb 21, 2008

Skidzz

Tinkerbell
Apr 11, 2005
328
1
19
Salt Lake City, UT
Feb 21, 2008
#1
  • Feb 21, 2008
  • #1
Ok, I just finished college and soon I should have a much better paying job. I'm also selling my house and I'm going to spend some of the money or so on the GT. Here's what I plan to do in the near future:

H&R springs, Bilstein S/S, LCA's, C/C plates.
New clutch
Rims/tires
Paint touch-up and new clear coat.
Cowl hood
Saleen s281 spoiler
MAYBE Nitrous

My long-term goal, however, is to swap the engine for something I can supercharge. I was thinking of just going with a MPH short-block, but I'm not sure yet. Basically, my goal at first is to have a set-up that pushes just enough power for the stock transmission and rear-end to handle, but I also want a set-up that has the potential to make 500rwhp once I eventually change the transmission and beef up the rear.

So my questions are:
How much hp will the stock t-45 and rear-end handle?
What is the best set-up to go with to meet that number, but later on be able to crank up to my 500rwhp goal?
About how much am I looking at spending on parts?

The reason I ask is because I'm debating if I actually want to do this or just sell the GT later on and buy a Terminator. I know that the obvious answer is the latter, but there is a sentimental value in my GT because of the time/money/pride that I have in it.
 

Skidzz

Tinkerbell
Apr 11, 2005
328
1
19
Salt Lake City, UT
Feb 22, 2008
#2
  • Feb 22, 2008
  • #2
Bump
 

LaserSVT

Got FB banned again for saying nards
Founding Member
Nov 29, 1999
9,391
3,538
233
Feb 22, 2008
#3
  • Feb 22, 2008
  • #3
I can appreciate wanting to keep the car, I love my Cobra and want to make it as powerful as a Terminator since I can do a little at a time cause I cant afford a Termi. That being said if I had enough cash to cover the difference after selling my car I would buy one in a heartbeat.
 

NobleHdwe

New Member
Jan 19, 2008
16
0
0
Oklahoma
Feb 22, 2008
#4
  • Feb 22, 2008
  • #4
You may look at not putting too much into your current stang, and getting a different one to play with when money allows or whatever. Then use your current on more as a DD
 

Skidzz

Tinkerbell
Apr 11, 2005
328
1
19
Salt Lake City, UT
Feb 22, 2008
#5
  • Feb 22, 2008
  • #5
Well, I actually plan to buy a different car as my DD. Something with good gas-mileage and maybe AWD, and something that I won't be tempted to mod. I'm thinking about getting a mid-late 90's Audi A4. So, I plan to have the Model A, the DD, and a Mustang of some kind. I might even consider trying to buy a terminator motor from a wrecked cobra and dropping that into the GT...
 

NobleHdwe

New Member
Jan 19, 2008
16
0
0
Oklahoma
Feb 22, 2008
#6
  • Feb 22, 2008
  • #6
Hmmmmm I can see your problem now! I hate having to make decisions like that!! That's why I need to win the lottery!!!
 

Skidzz

Tinkerbell
Apr 11, 2005
328
1
19
Salt Lake City, UT
Feb 22, 2008
#7
  • Feb 22, 2008
  • #7
Anyway, back to my questions. First of all, how much hp can the stock T-45 and rear-end handle?
 
C

ceracer33

New Member
Aug 30, 2005
118
1
0
Feb 22, 2008
#8
  • Feb 22, 2008
  • #8
from what i've seen the stock t45 isnt gonna hold much more power than the engine can hold as well, around 400rwhp. i might stretch it out to around 500rwhp but it would be on borrowed time. i blew my t45 with 240rwhp spraying a 100 shot on top of that and street tires. as for the rear end, i dont trust them on slicks at all. a lot of people are in the 500rwhp+ range on stock rear end and no problems, but there are also a lot that grenaded it with much less power. i would plan to go ahead and build the rear and buy a new tranny before trying to make a lot of power but thats just me. i will be going to the dyno once i get my tb/plenum and long tubes on the car to see what i put down and get my tune perfect. i expect to be around 380rwhp on spray and im planning to build the rear and build a forged short block before i do any more mods. i already have a built tranny.
 

Skidzz

Tinkerbell
Apr 11, 2005
328
1
19
Salt Lake City, UT
Feb 22, 2008
#9
  • Feb 22, 2008
  • #9
Ok, so then if I'm looking to do it a little at a time, then I guess my goal is to have a supercharged engine setup that can be cranked down to about 350-380 rwhp while I have my stock tranni and rear, but something that I can crank up to about 500rwhp later on when I beef up the tranni and rear. So here's what I'm thinking:

MPH forged short-block w/ ported heads, blower cams, and paxton or vortech sc running a conservative tune. Would I be able to crank this set-up to about 500rwhp later on?
 

LaserSVT

Got FB banned again for saying nards
Founding Member
Nov 29, 1999
9,391
3,538
233
Feb 22, 2008
#10
  • Feb 22, 2008
  • #10
Yeah that setup will be good for 500+ rwhp with intercooler and a good fuel system (tank, pumps, lines, injectors and wiring upgrade). The rear and tranny will hold just fine IF you dond drag race it. On the street and even SCCA/NASA racing will be ok. Its only thoes hard launches with all that power that grenade the rear ends and kill the tranny. Well not ONLY but mostley anyway.
 
C

ceracer33

New Member
Aug 30, 2005
118
1
0
Feb 22, 2008
#11
  • Feb 22, 2008
  • #11
yea that is true, if ur not drag racing it and launching hard on dr's or slicks then the stock rear/tranny will be fine. i was talking about beffing it up to handle the power with slicks. i have a new goal of lifting the front wheels by the end of the summer, but i dont think its gonna happen.
 

LaserSVT

Got FB banned again for saying nards
Founding Member
Nov 29, 1999
9,391
3,538
233
Feb 22, 2008
#12
  • Feb 22, 2008
  • #12
Good goal Good luck!
 
C

CENTENNIALSTANG

Member
Apr 15, 2005
0
0
16
Houston
Feb 22, 2008
#13
  • Feb 22, 2008
  • #13
Skidzz said:
Ok, so then if I'm looking to do it a little at a time, then I guess my goal is to have a supercharged engine setup that can be cranked down to about 350-380 rwhp while I have my stock tranni and rear, but something that I can crank up to about 500rwhp later on when I beef up the tranni and rear. So here's what I'm thinking:

MPH forged short-block w/ ported heads, blower cams, and paxton or vortech sc running a conservative tune. Would I be able to crank this set-up to about 500rwhp later on?
Click to expand...

HMMMMM turning the boost up and down on the fly here you go, as for 500hp yep and more whatever you want a turbo gots. http://www.hellionpowersystems.com

As far as tranny issues, try for a T56 swap and good clutch if you know how to drive it will last forever. Rear end no biggie put a carrier and 31 axles on, thats pretty cheap. Motor wise MPH shortblock or MMR. Get turbo cams, port the heads and you got a roll racing machine and with a 2 step it wont be to slow from a dig either.


PREPARE TO WASTE ALOT OF MONEY
 

Skidzz

Tinkerbell
Apr 11, 2005
328
1
19
Salt Lake City, UT
Feb 22, 2008
#14
  • Feb 22, 2008
  • #14
Actually, I do plan to drag race, I just plan on running street tires until I beef up the rear.
 
You must log in or register to reply here.

Similar threads

Project Fox Revival (please send help)
  • sleep-e
  • Jan 21, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
3
Views
253
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jan 22, 2026
KRUISR
9
Engine Donor '00 Mountaineer meet '91 Fox
  • 91firecracker
  • May 11, 2026
  • Fox 5.0 Mustang Tech
  • 2 3
Replies
41
Views
931
Fox 5.0 Mustang Tech May 28, 2026
91firecracker
9
T
Hi
  • timotto
  • Dec 14, 2025
  • The Welcome Wagon
Replies
2
Views
150
The Welcome Wagon Dec 14, 2025
91AOD5.0LX
Suspension Harsh Ride
  • PonyGTrider
  • Mar 20, 2026
  • Fox 5.0 Mustang Tech
  • 2 3 4
Replies
62
Views
2K
Fox 5.0 Mustang Tech Apr 11, 2026
Noobz347
H
Forced Induction On3 Turbo Kit- Parts list NEEDED - 302 Stock Motor
  • Hirothecool1
  • Feb 27, 2026
  • Fox 5.0 Mustang Tech
  • 2
Replies
21
Views
1K
Fox 5.0 Mustang Tech Mar 7, 2026
slow84lx
S
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?