I'm ordering an electrical speedo, as well as an electrical fuel level gauge (AutoMeter Ultra-Lite).
My question is how can I get the electrical speedo to read properly? I know i'll have to get the sender that's sold seperately (there's two of them, not sure which one I will need). But how does those mount, etc.?
Also, if I used my stock gas tank sensor ('90 Mustang) would I have to order the 1989-Present Autometer gauge? It reads "Fits Most Ford Vehicles 1989-Current 16-158 ohm"
Those two things are preventing me from ordering. Hopefully someone could help me out.
Thanks in advance.
My question is how can I get the electrical speedo to read properly? I know i'll have to get the sender that's sold seperately (there's two of them, not sure which one I will need). But how does those mount, etc.?
Also, if I used my stock gas tank sensor ('90 Mustang) would I have to order the 1989-Present Autometer gauge? It reads "Fits Most Ford Vehicles 1989-Current 16-158 ohm"
Those two things are preventing me from ordering. Hopefully someone could help me out.
Thanks in advance.