Roush Got the bassani headers installed!

[justin]

Man does the car sound wicked! The install was a real pain in the ass! A buddy and I worked on it for about 9 hours all together. We just put the car on jack stands and had to lift the motor a little bit, take off the starter,move the steering shaft, and the oil filter. There isn't room to hardly do anything. My neck is killing from being all cramped up under there! Very happy with the end result. The Bassani ceramic headers,bassani o/r x pipe, and the Magnaflow/Saleen catback with the center exhaust has a pretty unique sound. The tunable induction cold air kit probably helps with the sound a little bit too.

Should get my SCT tuner any day now. I got a 3 customs tunes with my modifications from JMS Chip. Then I will dyno it sometime towards the beginning of summer and have it custom tuned from there. Hopefully I see some good numbers!

 

[saleen556]

What kind of #'s did you get out of your Bassani setup?

 

[justin]

I haven't been able to get to the dyno being that is about 3 hours away. I'm not sure how much power it added but you can feel it. I've seen a couple people with Saleens getting 10rwhp-18rwhp.

 

[saleen556]

That's what I have seen as well.I would like to see a dyno sheet since they are suppose to move the powerband up in the rpms.I am hoping for 420rwhp at 10lbs boost.

 

[justin]

Do you still have a stock bottem end? If so 420 is pushing it. My goal is to hit 400 to the wheels.

 

[saleen556]

Do you still have a stock bottem end? If so 420 is pushing it. My goal is to hit 400 to the wheels.

Yes stock bottom end.I've seen alot of guys pushing the limits so I am not too worried.If/when it gives I have my sights on a VT shortblock and possibly their stage 2 heads and blower cams.

 

[Probablecause]

i gained 15/15 to the tires.

KB 1.7 i/c 9lbs
bassani headers/o/r x pipe
borlas

403/421 to the ground. with the proper tune, the motor is good to go.