405/418 with a power curve as flat as a table top....I almost had the same exact setup and that's what I made lol
I got a start up tune and tried to run my car lastnight. It wouldn't idle but when I got it up to 1000rpms it would run fine. Think it's just a tune issue? It ended up flooding405/418 with a power curve as flat as a table top....I almost had the same exact setup and that's what I made lol
Yes... its a tune issue. Mine did the same thing. Start up tunes are rich as hell. Are you running 42# injectors and lightning mass air?
Do u have a boost-a-pump? If not , you will need one. Your fpdc will max out around 4200rpm
I have a Ford GT pump in mine and it flows 310lph and I needed one...not sure how the focus pump compares thoughI was told the focus 255lph pump is good for 450 rwhp
I guess we will see! My buddy ran this pump for 3000kms with 430rwhpI have a Ford GT pump in mine and it flows 310lph and I needed one...not sure how the focus pump compares though
405/418 with a power curve as flat as a table top....I almost had the same exact setup and that's what I made lol
2.73. It registers around 12-13#sdid you run the 2.93 pulley? if so, how much boost did you make?
Got to the dyno and my supercharger started making some pretty freaky noises. I was sold a bad blower. So now I'm waiting on a rebuilt one from steigmeierWhat were the numbers?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?