H/C/I....few questions...

[SPEEDYLIFSAVR]

I've done a lot of wrenching on stangs but Heads and Cam is a new arena for me .

I recently purchased a nice set of GT-40P's and an Explorer intake . The heads will be ported as well as the explorer lower . I was going to go with a set of 1.6 rr's and TF stage 1 cam . I was told this will be good for my application .

I recently came across a really good deal on a set of 1.65 RR's and an E cam . will these be good for my application . The car will also be upgraded with 3.73's and probably a 100 shot down the road .

 

[LEE93COBRA]

yes. It will run pretty good. Should put it in the 11's on juice

 

[sweet88gt]

I had a E cam in my car with heads and its ok. I switched out to TF stage 1 and didnt feel any different. I have 1.6 RR and with the setup it will run pretty strong. I sprayed 125 shot a few times and it is pretty fun. After all of the tire spinning it will pull hard. Its worth the effort. I know I will never drive another mustang without aftermarket heads. It woke my car up.