• Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech

H&R Sport Springs (install) NEED HELP!

  • Thread starter Thread starter zgarske1038
  • Start date Start date May 8, 2004

zgarske1038

Member
Dec 7, 2003
222
0
17
Hilton Head Island, South Carolina
May 8, 2004
#1
  • May 8, 2004
  • #1
anyways yesterday i installed my h&r sport springs on my mustang it lowered them a good amount but my question is is it normal for some of the corners to be higher then the others..? because on my car my front drivers side sits lower then the front passenger side (i can barely fit 4 fingers in on drivers side & a little over 4 on the passenger) the same thing applys to the rear except the rear drivers side sits higher than the rear passenger same amount of fingers again...its noticable if you look for it that the car sits higher on one side to the other

my question is ... is this because i possibly missaligned pigtails of the springs .... i mean that they werent turned to the correct position? or is this just normal for new springs and should go away in 2 weeks are so plz help thanks!
 

Nuar

Founding Member
Apr 16, 2002
570
0
16
NB, CT
May 8, 2004
#2
  • May 8, 2004
  • #2
Well the springs are not all the same,,, two are meant for the rear of the car and two are meant for the front. Did you check that, when you put them in?

(well at least i know that Eibach springs are not all the same)
 

edcar01gt

New Member
Jan 6, 2003
327
0
0
san antonio, tx
May 8, 2004
#3
  • May 8, 2004
  • #3
yeah, make sure you put the rear springs on the rear and the front spring on the front....sounds like you could've put the sprigns on wrong, but i doubt that since the front ones are a lot taller that the rear ones...did you bolt your shocks/struts back on right....maybe shocks/struts are bad...i put them on my old gt and had no problems whatsoever....and yeah, check the pigtails..they should be pointing towards the drivers side door on the rear....and on the front, the a-arm should have the old markings of the originals, so just line them up to those...
 

zgarske1038

Member
Dec 7, 2003
222
0
17
Hilton Head Island, South Carolina
May 8, 2004
#4
  • May 8, 2004
  • #4
ya im positive i got the front ones in the front and the back ones in the back its actually starting to even out so i dont think that any thing is wrong just settling a little odd thats all thanks anyways guys
 
You must log in or register to reply here.

Similar threads

F
Rear Drum Brakes
  • Fri Guy
  • Jan 3, 2025
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2 3
Replies
54
Views
2K
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jan 8, 2025
Scrapla347
Tuners come on inside
  • squeak93
  • Feb 13, 2026
  • SVT Tech Forum
Replies
1
Views
258
SVT Tech Forum Feb 20, 2026
squeak93
J
For Sale [FOR SALE] 1991 Mustang Notchback / 90,000 Miles / ~15,000 mile motor / Lots of Upgrades
  • Johnnie_Casino
  • Apr 2, 2025
  • Fox Body Mustangs For Sale (1979-93)
Replies
0
Views
1K
Fox Body Mustangs For Sale (1979-93) Apr 2, 2025
Johnnie_Casino
J
0
V6 to V8 Swap info
  • 02_2v_Curtis
  • Jan 11, 2026
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
0
Views
723
1996 - 2004 SN95 Mustang -General/Talk- Jan 11, 2026
02_2v_Curtis
0
J
For Sale 2003 mustang GT
  • jimted79
  • Mar 22, 2025
  • SN95 Mustangs For Sale (1994-04)
Replies
0
Views
577
SN95 Mustangs For Sale (1994-04) Mar 22, 2025
jimted79
J
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?