Has anyone tried the Energy suspension tranny mount?

[01LaserRedCobra]

I was just curious if anyone has tried this new tranny mount? Also the motor mounts? Do you see a real benefit from swapping these out compare to stock. Also is it difficult to swap the motor mounts on a mod motor?

http://www.energysuspension.com/pages/whatsnew.html

 

[COramprat]

ENERGY SUSPENSION PRODUCTS ARE PROUDLY MADE IN AMERICA.

Thats a big plus in my book. Do you see a price list?

 

[mity2]

Now, I used their transmount busing on my TA. I have to tell you, they kinda suck. My TA now vibrate like my ex's dildo at certain RPM, and honestly, its benefit aside, I hate it...
I wouldn't do it unless i'm turning my car in to dedicated race car....

Now thats on T/A. Maybe mustang one is bit different?

 

[03ghoststang]

i would give those a tryand see how they are......

 

[blackink00]

i did the motor mounts on mine and i like them alot. the responce is better and no noticble vibration or anything like that. installation took about 3.5 hours cause i had to do it at my appartment complex so it was kinda hard but that is from jacking up to test drive. probebly the hardest part is taking out the starter and taking the old one out/ putting new one in. theres a trick to removing the starter though. hope this helps

 

[Spreadman]

I've got their endlinks and swaybar bushings....as well as A-arm bushings. I have Prothane tranny and motor mounts. I can't comment on the noise level as the exhaust and blower are louder than the tranny.

 

[Gearbanger 101]

End links, sway bar bushings and control arm bushings yes......but I'm with mity2. If you think your shifter vibrates now, wait until you've got a polyurethane transmission mount on there. Performance wise….unless you’ve got urethane bushings from one end of that car to the other, you’re not going to notice a thing. I’d pass and just go with a new stock mount if your old one has had it, or suck it up, convert the whole shooting match over and prepare to have my fillings shaken loose.

 

[NPIGT]

I have the motor mounts and like them alot. I also have the tranny mount but havent put it in yet. I will let you know.

 

[mity2]

how much is transmount? if its cheap enough, i'll try it

 

[01LaserRedCobra]

I believe the tranny mounts run about $80

http://mustangwarehouse.com/Merchan...ode=4.1128G&Category_Code=ENR&Product_Count=8

 

[Wes28376]

I'm with a few of the other guys. Stay away from the tranny mount. I installed one on my Jeep wrangler, it vibrated the jeep terribly. My wife seemed to like it for some reason though, lol. I ended up ordering the stock rubber one and installing it a few days later.