hci install question

[oosmytoo]

well finally ordered my trick flow street kit today, also ordered the sn95 adapter elbow and a new set of roller lifters. just wondering what else ill need to do this install? also im kind of low on funds. but what else should i buy to complete my combo? any idea what kind of power ill have?

 

[4Jenna]

I'm still running stock lifters, prob coulda saved yourself a few bucks there.
Gaskets (Head/Intake/Header/Valve Cover)
You keeping the stock rockers?

 

[oosmytoo]

trckflows kit comes with 1.6 rollers, pushrods, all the studs, new head and intake bolts, gasket set, double roll timing chain set, upper and lower intake, twisted wedge heads, valve covers, and stage one cam. then i bought that adapter elbow and went ahead and got new lifters mainly because im practicly replacing the whole top end might as well put new lifters. im pretty sure this is all i need to do the swap for now, unless you guys can think of anything else?

 

[4Jenna]

Damn, nice kit...sounds complete

 

[94TURBO5 O]

also im kind of low on funds. but what else should i buy to complete my combo? any idea what kind of power ill have?

Installs always exceed your max financial plan. You will always need something here or there and it always ends up being a lot more than you planned on spending.

 

[Killercanary]

What about fuel mods? ie injectors, fuel pump, tuning devise, etc?

 

[zenboy99]

What about a Mass air meter? You can still pick up the Pro-M 80mm for cheap.

I think its a good idea that you got new lifters, alot of engine builders suggested it to me. The lifter and cam wear into each other after awhile

 

[oosmytoo]

Installs always exceed your max financial plan. You will always need something here or there and it always ends up being a lot more than you planned on spending.

haha tell me about it, thats why i said im low on funds! dont want to spend any money till shes all put back together.

 

[oosmytoo]

What about fuel mods? ie injectors, fuel pump, tuning devise, etc?

im gonna do so, but like i said before money is kinda tight so hopefully i can get by with just the following mods. im guessing the only thing i might have to have right now is a tuner/chip, thats if my computer dont accept the cam. somebody told me once before that its a good idea to get a new MAF to wake it up a bit?

 

[mackey]

What part # was the kit?

 

[oosmytoo]

What part # was the kit?

TFS-K514-350-370 2049$ from summit and free shipping!

 

[mackey]

well looks like i gotta make a trip to the bank on wednesday Which lifters did you get? and which do you recommend?