Header gasket

ninety15.0

New Member
Mar 10, 2004
1,336
0
0
hey guys i have fms shortys and i just put a new motor in the car a couple months ago. All the header bolts are OEM but they were lock-tighted and torqued to spec and then retorqued at about 500 miles. I have this slight ticking/tapping/pattering sound at between 1200 and 2200 rpm. I'm thinking its either the roller rockers need to be adjusted or i have a blown/leaking header gasket. My question is if i rip the header off to check the gaskets condition am i going to have to buy a new one if it appears good? The motor has about 1000 miles or so...Is this the only way i'm going to know if the gasket is good? any other :rolleyes: (easier) methods? Thanks for the help
Nick
 
An easyer method of checking the exaust gasket to see if they are leaking is to get a vac/fuel line 5/16 or so and place one end to your ear and run the other around the header. If it is leaking you will hear it, well the air passing through or by the other end of the hose or you can go to your local auto parts store and pick up a stehoscope and take the pick up off the end and use the hose off of that to listen. This works well, done it a thousand times. If you take off your header gasket than yes you more than likely will have to replace them. You can purchace a set of copper gaskets and reuse them in the future. Best of luck
 
sounds good to me man...i'll give it a try sometime this week, its just such a pain in the ass to get the header off with the whole exhaust on there and the car not being on a lift haha.