Headers and Engine Install???

Hey guys, this is my first time dropping an engine in to the II! Do I install the headers onto the heads:
* before I drop it in
* After I drop it in
* While I am dropping it in
* Don't need no stinking headers

Also any other helpful hints?


- 66 289 cid Block
- 66 Hypo 289 Heads 54cc (Prof stage 2 ported & polished heavy duty springs, etc...)
- 78 302 crank
- 1405 600 cfm Edelbrock
- Edelbrock RPM Dual plane Intake
- Headman Headers (With that one stuipd one that goes under the crossmember which I will be rerouting)
- Roller rockers
- Edelbrock RPM Cam
- Forged TRW Pistons
- Professionaly Blueprinted (yea right, like anyone can't blueprint an engine) & ballanced (ok so I can't do this myself)
- Sticking witht he Rad4 for now
- Stock 3.00 gears
- Stage 2 clutch & pressure plate (Probably did not need them but I do not like changing clutches)
- Just about everything is new, except for my dented up oilpan... Do you realize how expenseive those things are!!!

Anyway, any help would be greatly appreciated,
Chad

I would like to thank everyone that posted their install process and other hints!

Looks like I will try to maneuver the engine in with the headers roughly in place. It did not look like there would be enough room to fit them through after the engine was in!

Again thanks for your assistance and I will take lots of pictures and maybe even video of us trying to get it in on Friday!

Wish me luck!

Chad