Heading to the dyno tomorrow, hope the cluth will hold

Im sure some of you have seen my thread on my SPEC II Clutch still slipping b/c it hasent been broken in compleatly. A bunch of us are heading to the dyno down in Concord N.H tomorrow. 3 pulls for $40 w/ the A/F ratio and they can weigh your car. Right now I have 100 miles on the clutch and its acting better and better the more I drive it. I have to go to work today, thats 20 miles in 20 miles back. Plus about 115 miles from here to concord N.H so that puts me in the ball park of 260 Miles. It doesent help that alot of the driving will be done on the Interstate on the way to concord. I just want it to hold so I can get an accurate A/F ratio reading in the upper RPM's.

I have it set in my own mind for what I'll pull on the dyno, anyone here have any guess's on what I'll pull, closest to the actual #'s gets a cookie

PS: Things not included in the sig.... AL Drive shaft, Kirban FPR, 190 Fuel pump.

baglock1 said:

Hmmm, coincidence? I'm headed out to the dyno tomorrow too (for the baseline prior to installing the roush intake for those who are following). The deal we're getting is nowhere near as good though. That's going to annoy me all day now.

Click to expand...

were getting a club discount rate. I think its usually $50 for 3 pulls w/ the A/f Ratio. Its not just for " our " club, anyone in the area is invited to come, we have a post on it in the North east and besides the 7 of us that are going theres quite a few more people signed up, should be a great turn out.