Headlight adjustment.... Specs????

[1993SSP]

Hey guys, Whats the proper headlight adjustment on a fox body, how far from the wall should the car be and at what height should the center of the beams be?? thanks

 

[jrichker]

The adjustment screws are upper inside and lower outside screws. If the headlights were re-assembled properly, they will have a 5/32" hex on the screw. You can use a 1/4" ratchet with a 5/32" socket. The upper screws can be reached with the hood up, while the lower screws may require you to lay on the ground in front of the car and reach them from the bottom.

To align the headlights, find a level spot with a wall 25-30 feet away. Disconnect the driver light and align up the passenger light so that the light pattern is slightly below of the actual centerline of the headlight. This is to illuminate the right hand side of the road. Reconnect the driver light and disconnect the passenger light. The driver light should be aimed so that the light pattern on the wall is inward about 6" and slightly below the centerline of the headlight. This keeps you from blinding the oncoming cars. Disconnecting and reconnecting the headlights helps to show which headlight is shining in what direction. Reproduction headlights may shine in several directions at the same time, making it very difficult to align them if both lights are on at the same time

 

[BlackGT89]

Yeah, I ground the factory alignment pins off of my headlights because I got tired of scraping my knuckles on them when I was washing my car. Sure is painful, especially if your hands are cold ! I usually just drape a jacket or something over the headlight I'm not aligning.