Hellion Twin Turbo Install And Now Maf Issues

syck GT · Aug 21, 2016

Hey everyone.

I installed a hellion twin turbo kit on my 2016.

Going to try and tune it and the MAF readings are coming out lower then stock.

Just seeing if anyone has run into an issue like this with this kit or any other turbo kit.

Also a boost leak test has been done twice. She is making a solid 7psi.

Thanks in advance!

Sent from my SAMSUNG-SM-N920A using Tapatalk

84Ttop · Aug 22, 2016

Is this a blow through or draw through MAF? In know in the coyote blower applications I use the stock sensor in a blow through 4" housing. I also use a honeycomb before the MAF to straighten the air for a better signal. 11psi and 676rwhp and zero issues.

syck GT · Aug 22, 2016

84Ttop said:
Is this a blow through or draw through MAF? In know in the coyote blower applications I use the stock sensor in a blow through 4" housing. I also use a honeycomb before the MAF to straighten the air for a better signal. 11psi and 676rwhp and zero issues.

Good question. All I know is every other person with this kit I have talked to used the stock MAF with no issue. Lol so I am not sure

Sent from my SAMSUNG-SM-N920A using Tapatalk

84Ttop · Aug 22, 2016

Was the harness cut and spliced at all or is it stock length? I've also seen poor solder connections give issues when harnesses are extended.
Have you tried to call Urist to see what there take is on this?

syck GT · Aug 22, 2016

84Ttop said:
Was the harness cut and spliced at all or is it stock length? I've also seen poor solder connections give issues when harnesses are extended.
Have you tried to call Urist to see what there take is on this?

Stock length. No cutting or extending needed.

I have called hellion twice and 1 other shop with no luck. They keep saying boost leak but I have verified multiple times there is no leak.

Sent from my SAMSUNG-SM-N920A using Tapatalk

15GTrob · Aug 22, 2016

How are you gauging there isn't a boost leak?

syck GT · Aug 22, 2016

15GTrob said:
How are you gauging there isn't a boost leak?

3 boost leak tests...

and boost gauge showing 7psi....

Sent from my SAMSUNG-SM-N920A using Tapatalk

15GTrob · Aug 22, 2016

I was only asking because I'm not sure how you would test that.

syck GT · Aug 22, 2016

15GTrob said:
I was only asking because I'm not sure how you would test that.

Oh no worries.

Basically remove both air filters. Put a special cap on one turbo to block it off and then a cap on 2nd turbo with a fitting to allow you to use air compressor to pressurize system.

Turned up to 25psi and it held no issues

Sent from my SAMSUNG-SM-N920A using Tapatalk

Hellion Twin Turbo Install And Now Maf Issues

syck GT

New Member

84Ttop

They make new pistons every day, so why worry?

syck GT

New Member

84Ttop

They make new pistons every day, so why worry?

syck GT

New Member

15GTrob

syck GT

New Member

15GTrob

syck GT

New Member

Similar threads

Hellion Twin Turbo Install And Now Maf Issues

New Member

They make new pistons every day, so why worry?

New Member

They make new pistons every day, so why worry?

New Member

New Member

New Member

Similar threads

Privacy & Transparency

Privacy & Transparency