Help on 5lug axles.....

808Gt

Founding Member
Apr 21, 2002
115
0
16
Hawaii
I am changing my rear axles to ranger 5-lug axles this week and had a question about the lube and friction modifier..... My question is when I finish installing the axles on the rear end, and re-installing the cover How or when and were do you put the lube oil in and friction modifier?? and do you add the lud and friction modifier together??
 
You put the cover back on, using RTV as a gasket, and add oil through the fill plug on the drivers side front.

I would make sure you can get the plug out before you start. It usually takes a 3/8 drive socket extension.

I usually put the oil in first and then add the friction modifier in the middle or at the end.

It is sometimes a pain to fill, I have ended up using one of those cheap pumps that fits on the oil bottle, and a length of hose to fit up into the axle. This is with the car on stands under the axle.

Check a manual for the fill level. On my 7.5 axles, it is about 1 to 1 1/2 in below the bottom of the plug.
 
808Gt said:
also should i clean the axles then oilit up before installing them......?

I would clean them the best you can...button everthing up..the oil/modifier is the final step..

As far as when to add the friction modifier..put about 1/2 of the first bottle in, then the modifier, then top it off.

That's how i did it, worked for me..:D
 
if you wait til last to put the modifier then obviously you run the risk of it topping out and then it just pouring out. +1 for adding one bottle of lube then the modifier, that is what I did when I did my gear swap.
 
Had a question about the MC.....

I got all the parts for the rear convrsion, going to stay drums for now...
But i will be buying sn95 front brakes and wanted to know if i can still use my stock MC for now till i get mor $$$