• Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech

HELP! Vortech'd 04 GT - Oil getting in Powerpipe, car barely running....

  • Thread starter Thread starter Sinister SN95
  • Start date Start date Nov 20, 2007
Prev
  • 1
  • 2
First Prev 2 of 2
D

darkside03gt

Member
Feb 19, 2007
851
8
18
Sacramento CA
Nov 21, 2007
#21
  • Nov 21, 2007
  • #21
I think you have an engine problem not a supercharger problem
 

04YELLOWGT

Active Member
Jun 29, 2005
1,135
2
39
Indiana
Nov 21, 2007
#22
  • Nov 21, 2007
  • #22
darkside03gt said:
I call totall on the synthetic causing superchargers to fail. NO way vortech puts thier supercharger on cars that are required to run full synthetic like the corvette camaro and lexus. also our gts service manual recommends a synthetic blend. If that was the case those OTHER guys would have nothing but problems. total
Click to expand...

Well read the Vortech Manual it says right in there.
 

speed545

Member
Mar 21, 2003
458
1
18
Montreal, canada
www.freeloadmp3.com
Nov 21, 2007
#23
  • Nov 21, 2007
  • #23
I actually have the same problem. V2SQ is new from last may,has 1500 miles on it and started to leak after 500 miles.

First i thought it was coming from the passenger side of the valv cover so i installed an oil separator. Cleaned everything after.

Still oil in the Power pipe and the tube from the driver side is dry as my grand ma.

Its a blown seal that s taking oil from inside the unit into the discharge pipe and into the plenum. Oil is getting sucked from the intake of the blower thru the AIC.

Mine got so worst, the bearings went also. Dont ask me why but the sound out of that blower is scary as sh...it

I m about to get it out of the car and to Vortech.
 

speed545

Member
Mar 21, 2003
458
1
18
Montreal, canada
www.freeloadmp3.com
Nov 21, 2007
#24
  • Nov 21, 2007
  • #24
And also, dont run it like that. oil on the MAF will cause the car to run lean and kaboom you go
 
D

darkside03gt

Member
Feb 19, 2007
851
8
18
Sacramento CA
Nov 21, 2007
#25
  • Nov 21, 2007
  • #25
04YELLOWGT said:
Well read the Vortech Manual it says right in there.
Click to expand...

NO it does not. go to vortech online and look ant the install manual on the third or so page down it specifically says to use "a high grade sf oil or a quality synthetic"
 

speed545

Member
Mar 21, 2003
458
1
18
Montreal, canada
www.freeloadmp3.com
Nov 21, 2007
#26
  • Nov 21, 2007
  • #26
speed545 said:
I actually have the same problem. V2SQ is new from last may,has 1500 miles on it and started to leak after 500 miles.

First i thought it was coming from the passenger side of the valv cover so i installed an oil separator. Cleaned everything after.

Still oil in the Power pipe and the tube from the driver side is dry as my grand ma.

Its a blown seal that s taking oil from inside the unit into the discharge pipe and into the plenum. Oil is getting sucked from the intake of the blower thru the AIC.

Mine got so worst, the bearings went also. Dont ask me why but the sound out of that blower is scary as sh...it

I m about to get it out of the car and to Vortech.
Click to expand...

Here s the sound

http://videos.streetfire.net/video/6ffd9f72-8f20-4e13-a077-99ed0164fe73.htm
 

BennyBlown2v

New Member
Dec 9, 2004
1,233
1
0
38
Carmel, INdiana
www.indycarz.com
Nov 21, 2007
#27
  • Nov 21, 2007
  • #27
That sounds just like my friends blower when it blew up.
 

smokin00GT

New Member
Mar 22, 2007
80
0
0
United States
Nov 21, 2007
#28
  • Nov 21, 2007
  • #28
That supercharger does NOT sound good!!! Send it in ASAP while it is still under warranty.
 
C

Craiger77

Member
Feb 16, 2002
32
0
7
47
MD
Nov 23, 2007
#29
  • Nov 23, 2007
  • #29
I say its the SC. The car may not be running right because the oil has fouled the MAF
 

Sinister SN95

New Member
Jun 3, 2002
48
0
0
Nov 26, 2007
#30
  • Nov 26, 2007
  • #30
speed545 said:
I actually have the same problem. V2SQ is new from last may,has 1500 miles on it and started to leak after 500 miles.

First i thought it was coming from the passenger side of the valv cover so i installed an oil separator. Cleaned everything after.

Still oil in the Power pipe and the tube from the driver side is dry as my grand ma.

Its a blown seal that s taking oil from inside the unit into the discharge pipe and into the plenum. Oil is getting sucked from the intake of the blower thru the AIC.

Mine got so worst, the bearings went also. Dont ask me why but the sound out of that blower is scary as sh...it

I m about to get it out of the car and to Vortech.
Click to expand...

My blower doesn't sound nearly as bad as what yours is, but i do have those same exact issues. I put a breather on my drivers side valve cover, and a oil separator on the passenger side just this weekend. No oil in either, so i'm assuming that oil is back in the powerpipe and i didnt' even his 1 pound of boost the whole time.




Craiger77 said:
I say its the SC. The car may not be running right because the oil has fouled the MAF
Click to expand...

I jsut cleaned everything out, the car still is idling kinda funny... and i still have to hold the gas down and start it to get it running, rev it up a bit just to get it to idle... i haven't driven it into boost at all this whole weekend, goign to check tonight to see if more oil is in there. Is it possible, even with the cleaning, that the MAF is bad now?
 

BennyBlown2v

New Member
Dec 9, 2004
1,233
1
0
38
Carmel, INdiana
www.indycarz.com
Nov 26, 2007
#31
  • Nov 26, 2007
  • #31
Sinister SN95 said:
My blower doesn't sound nearly as bad as what yours is, but i do have those same exact issues. I put a breather on my drivers side valve cover, and a oil separator on the passenger side just this weekend. No oil in either, so i'm assuming that oil is back in the powerpipe and i didnt' even his 1 pound of boost the whole time.






I jsut cleaned everything out, the car still is idling kinda funny... and i still have to hold the gas down and start it to get it running, rev it up a bit just to get it to idle... i haven't driven it into boost at all this whole weekend, goign to check tonight to see if more oil is in there. Is it possible, even with the cleaning, that the MAF is bad now?
Click to expand...

Yes. The coating on the wires can get worn off with oil, as well as cleaning products. You should put your car back to stock if you still have the injectors/maf/intake laying around, then ship the head unit back to vortech - you can run a stock belt on their if you have to without changing anything around.
 
Prev
  • 1
  • 2
First Prev 2 of 2
You must log in or register to reply here.

Similar threads

J
Progress Thread Family member 1989 GT- Backstory and updates
  • JRC99
  • Apr 19, 2025
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
15
Views
1K
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Oct 26, 2025
JRC99
J
98 GT PI Swapped Engine Fires, Dies Immediately NOT PATS
  • MMccPerformance
  • Dec 2, 2023
  • SN95 4.6L Mustang Tech
Replies
3
Views
2K
SN95 4.6L Mustang Tech Dec 20, 2023
Yel2002GTAuto
Y
D
1New recruit, hello, and help i have no clue what I'm doing anymore
  • Droseph18
  • Jul 3, 2019
  • SN95 4.6L Mustang Tech
Replies
3
Views
1K
SN95 4.6L Mustang Tech Jul 7, 2019
08GT500
R
Fox Closed PCV System, Dual Valve Catch Can
  • RTW0223
  • Dec 6, 2019
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
3
Views
14K
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Dec 30, 2021
jay98
Engine Head gasket or what?
  • Foxbody1988
  • Jan 17, 2020
  • Fox 5.0 Mustang Tech
Replies
8
Views
4K
Fox 5.0 Mustang Tech Jan 19, 2020
7991LXnSHO
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?